Viscosity relaxation

E. H. Grant. J. Chem, Phys. 26, 1575-7 (1957). Dielectric relaxation, viscosity water. 

In this equation 77 is the initial relaxation viscosity factor, proportional to the relaxation... 

FIG. 17-34. Plots with logarithmic scales of the stress relaxation viscosity if"(t) after cessation of flow for the solution of Fig. 17-32. Shear rates from top to bottom same as in Fig. 17-32. Dashed line is ri (t) + )j (t) for 7 = 0.170 X 10 s . (Osaki, Einaga, Yamada, and Kurata. ) Reproduced, by permission, from Polymer Journal. 

The list of experimentally accessible properties of colloid solutions is the same as the list of accessible properties of polymer solutions. There are measurements of single-particle diffusion, mutual diffusion and associated relaxation spectra, rotational diffusion (though determined by optical means, not dielectric relaxation), viscosity, and viscoelastic properties (though the number of viscoelastic studies of colloidal fluids is quite limited). One certainly could study sedimentation in or electrophoresis through nondilute colloidal fluids, but such measurements do not appear to have been made. Colloidal particles are rigid, so internal motions within a particle are not hkely to be significant the surface area of colloids, even in a concentrated suspension, is quite small relative to the surface area of an equal weight of dissolved random-coil chains, so it seems unlikely that colloidal particles have the major effect on solvent dynamics that is obtained by dissolved polymer molecules. 

Steam is injected into a reservoir to reduce oil viscosity and make it flow more easily. This technique is used in reservoirs containing high viscosity crudes where conventional methods only yield very low recoveries. Steam can be injected in a cyclic process in which the same well is used for injection and production, and the steam is allowed to soak prior to back production (sometimes known as Huff and Puff). Alternatively steam is injected to create a steam flood, sweeping oil from injectors to producers much as in a conventional waterflood. In such cases it is still found beneficial to increase the residence (or relaxation) time of the steam to heat treat a greater volume of reservoir. 

Figure IV-10 illustrates how F may vary with film pressure in a very complicated way although the v-a plots are relatively unstructured. The results correlated more with variations in film elasticity than with its viscosity and were explained qualitatively in terms of successive film structures with varying degrees of hydrogen bonding to the water substrate and varying degrees of structural regularity. Note the sensitivity of k to frequency a detailed study of the dispersion of k should give information about the characteristic relaxation times of various film structures.

There is one important caveat to consider before one starts to interpret activation volumes in temis of changes of structure and solvation during the reaction the pressure dependence of the rate coefficient may also be caused by transport or dynamic effects, as solvent viscosity, diffiision coefficients and relaxation times may also change with pressure [2]. Examples will be given in subsequent sections. 

The relation between the microscopic friction acting on a molecule during its motion in a solvent enviromnent and macroscopic bulk solvent viscosity is a key problem affecting the rates of many reactions in condensed phase. The sequence of steps leading from friction to diflfiision coefficient to viscosity is based on the general validity of the Stokes-Einstein relation and the concept of describing friction by hydrodynamic as opposed to microscopic models involving local solvent structure. In the hydrodynamic limit the effect of solvent friction on, for example, rotational relaxation times of a solute molecule is [ ]... 

Figure A3.6.6. Viscosity dependence of rotational relaxation times of (ran.s -stilbene hr ethane (open circles) andn-octane (fiill circles) [89].

Small molecules in low viscosity solutions have, typically, rotational correlation times of a few tens of picoseconds, which means that the extreme narrowing conditions usually prevail. As a consequence, the interpretation of certain relaxation parameters, such as carbon-13 and NOE for proton-bearing carbons, is very simple. Basically, tlie DCC for a directly bonded CH pair can be assumed to be known and the experiments yield a value of the correlation time, t. One interesting application of the measurement of is to follow its variation with the site in the molecule (motional anisotropy), with temperature (the correlation... 

From SCRP spectra one can always identify the sign of the exchange or dipolar interaction by direct exammation of the phase of the polarization. Often it is possible to quantify the absolute magnitude of D or J by computer simulation. The shape of SCRP spectra are very sensitive to dynamics, so temperature and viscosity dependencies are infonnative when knowledge of relaxation rates of competition between RPM and SCRP mechanisms is desired. Much use of SCRP theory has been made in the field of photosynthesis, where stnicture/fiinction relationships in reaction centres have been connected to their spin physics in considerable detail [, Mj. 

There are a number of important concepts which emerge in our discussion of viscosity. Most of these will come up again in subsequent chapters as we discuss other mechanical states of polymers. The important concepts include free volume, relaxation time, spectrum of relaxation times, entanglement, the friction factor, and reptation. Special attention should be paid to these terms as they are introduced. 

Of the adjustable parameters in the Eyring viscosity equation, kj is the most important. In Sec. 2.4 we discussed the desirability of having some sort of natural rate compared to which rates of shear could be described as large or small. This natural standard is provided by kj. The parameter kj entered our theory as the factor which described the frequency with which molecules passed from one equilibrium position to another in a flowing liquid. At this point we will find it more convenient to talk in terms of the period of this vibration rather than its frequency. We shall use r to symbolize this period and define it as the reciprocal of kj. In addition, we shall refer to this characteristic period as the relaxation time for the polymer. As its name implies, r measures the time over which the system relieves the applied stress by the relative slippage of the molecules past one another. In summary. 

In connection with a discussion of the Eyring theory, we remarked that Newtonian viscosity is proportional to the relaxation time [Eqs. (2.29) and (2.31)]. What is needed, therefore, is an examination of the nature of the proportionality between the two. At least the molecular weight dependence of that proportionality must be examined to reach a conclusion as to the prediction of the reptation model of the molecular weight dependence of viscosity. 

The Newtonian viscosity is given by the product of the relaxation time and the Hookean modulus. This result was anticipated in the discussion of Eqs. (2.29) and (2.31). 

Viscosity is considerably more sensitive to temperature than elasticity. By varying the temperature, the relaxation time of the polymer will be changed. Hence different mechanical response might be expected on a fixed laboratory time scale for samples examined at different temperatures. 

The Maxwell and Voigt models of the last two sections have been investigated in all sorts of combinations. For our purposes, it is sufficient that they provide us with a way of thinking about relaxation and creep experiments. Probably one of the reasons that the various combinations of springs and dash-pots have been so popular as a way of representing viscoelastic phenomena is the fact that simple and direct comparison is possible between mechanical and electrical networks, as shown in Table 3.3. In this parallel, the compliance of a spring is equivalent to the capacitance of a condenser and the viscosity of a dashpot is equivalent to the resistance of a resistor. The analogy is complete... 

Relative viscosity Relaxation Relaxation spectrometry Relays... 

---