Reductive elimination coupling

A related topic that was already discussed in these first DFT/MM works is that of branching. The scheme shown in Fig. 1 would always produce always a linear polymer if ethylene was used as olefin. But a simple process of / C-H oxidative addition/reductive elimination, coupled with olefin rotation, can produce a branched polymer, as shown in Fig. 4. Calculations on the branching process for cationic diimine Ni(II) complexes [36, 37] indicated a small increase between 0.9 and 2.5 kcal/mol in the barrier for this process, associated with the introduction of the bulky substituents in the catalysts. 

This iron anion is a good soft nucleophile for alkyl halides and can be used twice over to produce first a monoanion with one alkyl group and then a neutral complex with two alkyl groups and four CO ligands. Each of these complexes has 18 electrons. If extra CO is added by increasing the pressure, CO inserts into one Fe—C bond to form an iron acyl complex. Finally, reductive elimination couples the acyl group to the other alkyl group in a conceptually simple ketone synthesis. It does not matter which Fe—C bond accepts the CO molecule the same unsymmetrical ketone is produced at the end. 

Three-component coupling with vinylstannane. norbornene (80). and bro-mobenzene affords the product 91 via oxidative addition, insertion, transme-tallation, and reductive elimination[85]. Asymmetric multipoint control in the formation of 94 and 95 in a ratio of 10 1 was achieved by diastereo-differ-entiative assembly of norbornene (80), the (5 )-(Z)-3-siloxyvinyl iodide 92 and the alkyne 93, showing that the control of four chiralities in 94 is possible by use of the single chirality of the iodide 92. The double bond in 92 should be Z no selectivity was observed with E form[86]. 

The carbonylation of aryl iodides in the presence of alkyl iodides and Zn Cu couple affords aryl alkyl ketones via the formation of alkylzinc species from alkyl iodides followed by transmetallation and reductive elimination[380]. The Pd-catalyzed carbonylation of the diaryliodonium salts 516 under mild conditions in the presence of Zn affords ketones 517 via phenylzinc. The a-diketone 518 is formed as a byproduct[381],... 

The unsaturated c.vo-enol lactone 17 is obtained by the coupling of propargylic acetate with 4-pentynoic acid in the presence of KBr using tri(2-furyl)-phosphine (TFP) as a ligand. The reaction is explained by the oxypalladation of the triple bond of 4-pentynoic acid with the ailenyipailadium and the carbox-ylate as shown by 16, followed by reductive elimination to afford the lactone 17. The ( -alkene bond is formed because the oxypalladation is tnins addition[8]. 

Tandem cyclization/3-substitution can be achieved starting with o-(trifluoro-acetamido)phenylacetylenes. Cyclization and coupling with cycloalkenyl trif-lates can be done with Pd(PPh3)4 as the catalyst[9]. The Pd presumably cycles between the (0) and (II) oxidation levels by oxidative addition with the triflate and the reductive elimination which completes the 3-alkenylation. The N-protecting group is removed by solvolysis under the reaction conditions, 3-Aryl groups can also be introduced using aryl iodides[9]. 

Treatment of hexafluoroacetone with a P(lll) species results either in formation of five membered ring systems via reductive CC coupling of two molecules of hexafluoroacetone [275, 276 277, 278, 279 280, 281] (equation 60) or in reductive fluoride elimination [282] (equation 61)... 

Reductive elimination—to yield the coupling product 3 and regeneration of the catalytically active palladium-(O) complex 5. 

As inert as the C-25 lactone carbonyl has been during the course of this synthesis, it can serve the role of electrophile in a reaction with a nucleophile. For example, addition of benzyloxymethyl-lithium29 to a cold (-78 °C) solution of 41 in THF, followed by treatment of the intermediate hemiketal with methyl orthoformate under acidic conditions, provides intermediate 42 in 80% overall yield. Reduction of the carbon-bromine bond in 42 with concomitant -elimination of the C-9 ether oxygen is achieved with Zn-Cu couple and sodium iodide at 60 °C in DMF. Under these reaction conditions, it is conceivable that the bromine substituent in 42 is replaced by iodine, after which event reductive elimination occurs. Silylation of the newly formed tertiary hydroxyl group at C-12 with triethylsilyl perchlorate, followed by oxidative cleavage of the olefin with ozone, results in the formation of key intermediate 3 in 85 % yield from 42. 

The postulated steps that constitute the Suzuki coupling process are shown in Scheme 25. After oxidative addition of the organic halide to the palladium(o) catalyst, it is presumed that a metathetical displacement of the halide substituent in the palladium(ii) complex A by ethoxide ion (or hydroxide ion) takes place to give an alkoxo-palladium(ff) complex B. The latter complex then reacts with the alkenylborane, generating the diorganopalladium complex C. Finally, reductive elimination of C furnishes the cross-coupling product (D) and regenerates the palladium(o) catalyst. 

In the direct coupling reaction (Scheme 30), it is presumed that a coordinatively unsaturated 14-electron palladium(o) complex such as bis(triphenylphosphine)palladium(o) serves as the catalytically active species. An oxidative addition of the organic electrophile, RX, to the palladium catalyst generates a 16-electron palladium(n) complex A, which then participates in a transmetalation with the organotin reagent (see A—>B). After facile trans- cis isomerization (see B— C), a reductive elimination releases the primary organic product D and regenerates the catalytically active palladium ) complex. 

Although analogous to the direct coupling reaction, the catalytic cycle for the carbonylative coupling reaction is distinguished by an insertion of carbon monoxide into the C-Pd bond of complex A (see A—>B, Scheme 31). The transmetalation step-then gives trans complex C which isomerizes to the cis complex D. The ketone product E is revealed after reductive elimination. 

Sect. 2.1.1) and [3C+2S] cyclopentene derivatives. The product distribution can be controlled by choosing the appropriate reaction conditions [72]. Moreover, the cyclopentene derivatives are the exclusive products from the coupling of fi-pyrrolyl-substituted carbene complexes [72b,c] (Scheme 25). The crucial intermediate chromacyclobutane is formed in an initial step by a [2+2] cycloaddition. This chromacyclobutane rearranges to give the rf-complex when non-coordinating solvents are used. Finally, a reductive elimination leads to the formal [3C+2S] cyclopentene derivatives. 

Coupling of alkenylcarbene complexes and siloxy-substituted 1,3-dienes affords vinylcyclopentene derivatives through a formal [3C+2S] cycloaddition process. This unusual reaction is explained by an initial [4C+2S] cycloaddition of the electron-poor chromadiene system as the 471 component and the terminal double bond of the siloxydiene as the dienophile. The chromacyclohexene intermediate evolves by a reductive elimination of the metal fragment to generate the [3C+2S] cyclopentene derivatives [73] (Scheme 26). 

The general mechanism of coupling reactions of aryl-alkenyl halides with organometallic reagents and nucleophiles is shown in Fig. 9.4. It contains (a) oxidative addition of aryl-alkenyl halides to zero-valent transition metal catalysts such as Pd(0), (b) transmetallation of organometallic reagents to transition metal complexes, and (c) reductive elimination of coupled product with the regeneration of the zero-valent transition metal catalyst. 

The transmetallation reaction involves the transfer of the organic group from an organometallic species to a Pd(II) species and produces a trails Pd(II) species. Isomerization from the trans arrangement to a cis one is necessary prior to the reductive elimination step. Reductive elimination yields the coupled product and regenerates the transition metal catalyst. Because the reductive elimination is very fast, competing reactions leading to by-products are usually not observed. 

The general catalytic cycle for the coupling of aryl-alkenyl halides with alkenes is shown in Fig. 9.6. The first step in this catalytic cycle is the oxidative addition of aryl-alkenyl halides to Pd(0). The activity of the aryl-alkenyl halides still follows the order RI > ROTf > RBr > RC1. The olefin coordinates to the Pd(II) species. The coordinated olefin inserts into Pd—R bond in a syn fashion, p-Hydrogen elimination can occur only after an internal rotation around the former double bond, as it requires at least one /I-hydrogen to be oriented syn perpendicular with respect to the halopalladium residue. The subsequent syn elimination yields an alkene and a hydridopalladium halide. This process is, however, reversible, and therefore, the thermodynamically more stable (E)-alkene is generally obtained. Reductive elimination of HX from the hydridopalladium halide in the presence of a base regenerates the catalytically active Pd(0), which can reenter the catalytic cycle. The oxidative addition has frequently assumed to be the rate-determining step. 

The proposed catalytic cycle is shown in Scheme 31. Hence, FeCl2 is reduced by magnesium and subsequently coordinates both to the 1,3-diene and a-olefin (I III). The oxidative coupling of the coordinated 1,3-diene and a-olefin yields the allyl alkyl iron(II) complex IV. Subsequently, the 7i-a rearrangement takes place (IV V). The syn-p-hydride elimination (Hz) gives the hydride complex VI from which the C-Hz bond in the 1,4-addition product is formed via reductive elimination with regeneration of the active species II to complete the catalytic cycle. Deuteration experiments support this mechanistic scenario (Scheme 32). 

As a mechanistic hypothesis, the authors assumed a reduction of the Fe(+2) by magnesium and subsequent coordination of the substrates, followed by oxidative coupling to form alkyl allyl complex 112a. A ti—c rearrangement, followed by a syn p-hydride elimination and reductive elimination, yields the linear product 114 with the 1,2-disubstituted ( )-double bond (Scheme 29). This hypothesis has been supported by deuterium labeling experiments, whereas the influence of the ligand on the regioselectivity still remains unclear. 

Besides dissociation of ligands, photoexcitation of transition metal complexes can facilitate (1) - oxidative addition to metal atoms of C-C, C-H, H-H, C-Hal, H-Si, C-0 and C-P moieties (2) - reductive elimination reactions, forming C-C, C-H, H-H, C-Hal, Hal-Hal and H-Hal moieties (3) - various rearrangements of atoms and chemical bonds in the coordination sphere of metal atoms, such as migratory insertion to C=C bonds, carbonyl and carbenes, ot- and P-elimination, a- and P-cleavage of C-C bonds, coupling of various moieties and bonds, isomerizations, etc. (see [11, 12] and refs, therein). 

---