Rectifiers static thyristor

Static excitation system. This system consists of a static thyristor rectifier unit supplied from an external power source. The excitation current is connected to the rotor windings via conventional shprings. The static thyristor rectifier unit can be supplied on request. 

These are unidirectional and uncontrollablet static electronic devices and used as static switches and shown in Figure 6.14. A diode turns ON at the instant it becomes forward biased and OFF when it becomes reverse biased. By connecting them in series parallel combinations, they can be made suitable for any desired voltage and current ratings. Whether it is a transistor scheme or a thyristor scheme, they are used extensively where a forward conduction alone is necessary and the scheme calls for only a simple switching, without any control over the switching operation. They are used extensively in a rectifier circuit to convert a fixed a.c. supply to a fixed d.c. supply. 

In the case of rectifying elements, the total installed cost of a thyristor system is usually less than that of one based on diodes. Operating costs also are lower. Maintenance costs, as we saw in Section 8.3.1.2B, are lower because of the use of static, solid-state control devices rather than the mechanical switchgear of a tap changer. Rectification efficiency might be expected to suffer from the loss of part of the sine wave before firing, but this loss usually is comparable to the inefficiencies of the regulating transformers and the saturable reactors in a diode system. 

---