Reboilers, thermosyphon supports

Reboilers need to be located next to the tower they serve, except for the pump-through types, which can be located elsewhere. Fired heater reboilers are always located away from the associated tower and use a pump to circulate the bottoms. Ketde-type reboders are preferred from an operational and hydraulic standpoint because they can be designed without the worry of having to ensure sufficient head for circulation required by thermosyphon reboders. However, ketde reboders require a larger-diameter shed that is more cosdy, and the reboder must be supported at a sufficient elevation to get the product to the bottoms pump with adequate NPSH. 

Thermosyphon reboilers are the most economical type for most applications, but are not suitable for high viscosity fluids or high vacuum operation. They would not normally be specified for pressures below 0.3 bar. A disadvantage of this type is that the column base must be elevated to provide the hydrostatic head required for the thermosyphon effect. This will increase the cost of the column supporting-structure. Horizontal reboilers require less headroom than vertical, but have more complex pipework. Horizontal exchangers are more easily maintained than vertical, as tube bundle can be more easily withdrawn. 

Make a preliminary mechanical design for the vertical thermosyphon reboiler for which the thermal design was done as Example 12.9 in Chapter 12. The inlet liquid nozzle and the steam connections will be 50 mm inside diameter. Flat plate end closures will be used on both headers. The reboiler will be hung from four bracket supports, positioned 0.5 m down from the top tube plate. The shell and tubes will be of semi-killed carbon steel. 

---