Quadrature detection TPPI method

Proton-proton homonuclear decoupling has been performed by the ESLG decoupling sequence [46]. Quadrature detection in coj was achieved by using the time proportional phase increment method (TPPI) [47]. During the acquisition period, two pulse phase modulation (TPPM) heteronuclear decouphng ]48] was applied (Figure 7.6). 

Figure 13 Pulse sequence for the solid-state 31P—1H frequency-switched Lee-Goldburg (FSLG) experiment. Proton-proton homonuclear decoupling was performed by using the FSLG decoupling sequence. Quadrature detection in Wi was achieved by using the TPPI method. During the acquisition period, TPPM heteronuclear decoupling was applied.

As we saw in Section 3.4, quadrature phase detection discriminates between frequencies higher and lower than the pulse frequency, but it does not prevent foldover from frequencies higher than the Nyquist frequency. For a desired spectral width FT, there are two common methods for carrying out quadrature phase detection, as was indicated in Section 3.4. One method uses two detectors and samples each detector at FT points per second, thus acquiring 2 FT data in the form of FT complex numbers. The other (commonly called the Redfield method ) requires only a single detector and samples at 2 FT points per second while incrementing the phase of the receiver by 90° after each measurement. (In two-dimensional NMR studies, a variant of this method is usually called the rime-proportional phase incrementation, or TPPI, method.) Because these methods result in quite different treatment of folded resonances, we now consider these approaches in more detail. 

The quadrature detection mode is given as a suffix to the main sequence name me magnitude calculated, TPPI time proportional phase increment, E/A Echo / Antiecho The term "selective" is reserved exclusively for sequences using selective pulses. If selectivity is achieved using other methods this is defined using a different term. 

---