Propane undiluted

Propane undiluted 15-25 9 Resistant little or no change in weight small effect on mechanical properties generally suitable for practical use Nylatron Quadrant EPP... 

The result obtained from a Hj (5%)/Ar (95%) - TPR/MS in a soak-ramp mode test is shown in Figure 3 for a sample of DESOX. The onset temperature found for H S release in this case, approximately 580°C, is substantially higher than 450°C, the typical onset temperature found in the propane-TPR/MS test. The result was essentially identical in terms of the onset temperature for H S release even when undiluted was used as the reactant. Unlike the propane-TPR/MS tests, where the reaction products are essentially HjS only with virtually negligible amounts of SOj, Hj-TPR/MS tests always showed both SOj and HjS. These data, notably the pattern of change in the rates of SOj and H2S released with temperature in Figure 3, clearly demonstrate, as expected, that the reduction of S to S in step 3 is a consecutive reaction. 

In a recent study (120), measurements were made of the molar cyclization equilibrium constants Kx for cyclics (0(CH2)i00C0(CH2)4C0)x with x = 1—5 in an undiluted equilibrate of poly(decamethylene adipate) (PDA) at 423 K, and for cyclics (0(CH2)30C0(CH2 )2 CO)x with x = 1-7 in an undiluted equilibrate of poly(trimethylene succinate) (PTS) at the same temperature. The polymers were prepared from dimethyl adipate and decamethylene glycol and from dimethyl succinate and 1,3-propane diol using tetraisopropyltitanate and equilibrated at the required temperature in four-necked glass reaction kettles. Cyclics were extracted from the polymeric equilibrates and analysed by g.p.c. by methods described in Ref. (120). Individual cyclics were also prepared from the polyesters by the general pyrolytic method of Carothers and these were used for identification and calibration purposes. 

---