Print length

There are several performance tests for the return of motor function. One of the most often used is the Sciatic Function Index (SFT) derived by de Medinaceli et al. (1982) from a series of measurements of the walking gait of the rat. This index has been modified by Bain et al. (1989) for analysis of foot prints after peroneal nerve injury, and is known as the Peroneal Function Index (PFI). We and others have found that the quantitative analysis of toespread and of print length is more reliable indicator of recovery from peroneal nerve crush than is the PFI (Hare et al., 1993 Strand et al., 1993b). 

Repeat (15c) n. (1) The printing length of a plate cylinder as determined by one revolution of the plate cylinder gear. (2) The distance covered by a single unit of a pattern that is duplicated over and over, measured along the length of a fabric. 

The sizing defect method consists in selecting a defect in C-Scan image and framing it by an adjustable window in length and in width. Then, results are printed on the screen of the computer. 

Of course, all the data displayed on a computer can be printed as like as an inspection report (protocol) (see Fig. 1,2). The report contains inspection results in short the LMA readings divided in four levels number of LF per a lot of the rope length, e.g. per 6 dia. 

One last factor is the physical layout of the output stage when more than one output filter capacitor is used. The capacitors should be located radially symmetric from the output rectifier, and the printed circuit traces for the rectified voltage and the grounds should be of similar trace-widths and lengths. Any dissimilarity of these traces causes more series resistance and inductance to the... 

Power Supply Cookbook, Second Edition has been updated with the latest advances in the field of efficient power conversion. Efficiencies of between 80 to 95 percent are now possible using these new techniques. The major losses within the switching power supply and the modern techniques to reduce them are discussed at length. These include synchronous rectification, lossless snubbers, and active clamps. The information on methods of control, noise control, and optimum printed circuit board layout has also been updated. 

---