Primary alcohols pyridine

Esters derived from the primary alcohols are the most stable and those derived from the tertiary alcohols are the least stable. The decomposition temperature is lower in polar solvents, eg, dimethyl sulfoxide (DMSO), with decomposition occurring at 20°C for esters derived from the tertiary alcohols (38). Esters of benzyl xanthic acid yield stilbenes on heating, and those from neopentyl alcohols thermally rearrange to the corresponding dithiol esters (39,40). The dialkyl xanthate esters catalytically rearrange to the dithiol esters with conventional Lewis acids or trifluoroacetic acid (41,42). The esters are also catalytically rearranged to the dithiolesters by pyridine Ai-oxide catalysts (43) ... 

BzCl or BZ2O, Pyr, 0°. Benzoyl chloride is the most common reagent for the introduction of the benzoate group. Reaction conditions vaiy depending on the nature of the alcohol to be protected. Cosolvents such as CH2CI2 are often used with pyridine. Benzoylation in a polyhydroxylated system is much more selective than acetylation. A primary alcohol is selectively... 

Oxidations usually proceed in the dark at or below room temperature in a variety of solvents ranging from aqueous bicarbonate to anhydrous benzene-pyridine. Base is quite commonly used to consume the hydrogen halide produced in the reaction, as this prevents the formation of high concentrations of bromine (or chlorine) by a secondary process. The reaction time varies from a few minutes to 24 hours or more depending on the nature of the reagent and the substrate. Thus one finds that NBS or NBA when used in aqueous acetone or dioxane are very mild, selective reagents. The rate of these oxidations is noticeably enhanced when Fbutyl alcohol is used as a solvent. In general, saturated, primary alcohols are inert and methanol is often used as a solvent. 

If the temperature is not kept below 25°C during the reaction of primary alcohols with p-toluenesulfonyl chloride in pyridine, it is sometimes observed that the isolated product is not the desired alkyl p-toluenesulfonate but is instead the corresponding alkyl chloride. Suggest a mechanistic explanation for this observation. 

A recently discovered (2) oxidizing system promises to become very important for the oxidation of acid-sensitive compounds. The reagent is chromium trioxide-pyridine complex, which may be isolated after preparation and employed in nonaqueous solvents (usually methylene chloride). A remarkable feature of the reagent is that good yields of aldehydes are obtained by direct oxidation of primary alcohols. The preparation of the reagent and its use are given. 

When a primary alcohol is treated with p-toluenesulfonyl chloride at room temperature in the presence of an organic base such as pyridine, a tosvlate is formed. When the same reaction is carried out at higher temperature, an alkyl chloride is often formed. Explain. 

Dipyridiue-chromium(VI) oxide2 was introduced as an oxidant for the conversion of acid-sensitive alcohols to carbonyl compounds by Poos, Arth, Beyler, and Sarett.3 The complex, dispersed in pyridine, smoothly converts secondary alcohols to ketones, but oxidations of primary alcohols to aldehydes are capricious.4 In 1968, Collins, Hess, and Frank found that anhydrous dipyridine-chromium(VI) oxide is moderately soluble in chlorinated hydrocarbons and chose dichloro-methane as the solvent.5 By this modification, primary and secondary alcohols were oxidized to aldehydes and ketones in yields of 87-98%. Subsequently Dauben, Lorber, and Fullerton showed that dichloro-methane solutions of the complex are also useful for accomplishing allylic oxidations.6... 

Sulfonic esters are most frequently prepared by treatment of the corresponding halides with alcohols in the presence of a base. The method is much used for the conversion of alcohols to tosylates, brosylates, and similar sulfonic esters. Both R and R may be alkyl or aryl. The base is often pyridine, which functions as a nucleophilic catalyst, as in the similar alcoholysis of carboxylic acyl halides (10-21). Primary alcohols react the most rapidly, and it is often possible to sulfonate selectively a primary OH group in a molecule that also contains secondary or tertiary OH groups. The reaction with sulfonamides has been much less frequently used and is limited to N,N-disubstituted sulfonamides that is, R" may not be hydrogen. However, within these limits it is a useful reaction. The nucleophile in this case is actually R 0 . However, R" may be hydrogen (as well as alkyl) if the nucleophile is a phenol, so that the product is RS020Ar. Acidic catalysts are used in this case. Sulfonic acids have been converted directly to sulfonates by treatment with triethyl or trimethyl orthoformate HC(OR)3, without catalyst or solvent and with a trialkyl phosphite P(OR)3. ... 

The addition of Grignard reagents to aldehydes, ketones, and esters is the basis for the synthesis of a wide variety of alcohols, and several examples are given in Scheme 7.3. Primary alcohols can be made from formaldehyde (Entry 1) or, with addition of two carbons, from ethylene oxide (Entry 2). Secondary alcohols are obtained from aldehydes (Entries 3 to 6) or formate esters (Entry 7). Tertiary alcohols can be made from esters (Entries 8 and 9) or ketones (Entry 10). Lactones give diols (Entry 11). Aldehydes can be prepared from trialkyl orthoformate esters (Entries 12 and 13). Ketones can be made from nitriles (Entries 14 and 15), pyridine-2-thiol esters (Entry 16), N-methoxy-A-methyl carboxamides (Entries 17 and 18), or anhydrides (Entry 19). Carboxylic acids are available by reaction with C02 (Entries 20 to 22). Amines can be prepared from imines (Entry 23). Two-step procedures that involve formation and dehydration of alcohols provide routes to certain alkenes (Entries 24 and 25). 

Activation of a primary alcohol 174 by in situ mesylation and nucleophilic attack of a pyridine nitrogen atom was used in the last steps of a synthesis of cyclohexa[tf]quinolizidines 176. These compounds were obtained by direct NaBH4 reduction of intermediate pyridinium salts 175, and were proposed as tricyclic models containing the ABC-part of 8-azasteroids (Scheme 30) <1999T9269>. 

A rapid O-tosylation of a primary alcohol with tosyl chloride (1 equivalent) in the presence of 4-(N,N-dimethylamino)pyridine (1 equivalent) has been reported by Botta and coworkers (Scheme 6.118) [236], Microwave heating of the reaction mixture at 50 °C for 5 min provided the desired tosyl ester in 95% yield. 

Oxidation, of primary alcohols to aldehydes, 52, 5 of terminal olefins with chromyl chloride, 51, 6 of 2,4,4-trimethyl-1-pentene with chromyl chloride, 51, 4 with chromium trioxide-pyridine complex, 52, 5... 

It should be noted, in this connection, that there are pyridine nucleotide dehydrogenases which catalyze redox reactions which must occur in two steps. Hydroxymethylglutaryl CoA reductase (discussed on p. 51) is one example. Another is uridine diphosphate-glucose dehydrogenase, which catalyzes the oxidation of the C—6 of the glucose (i.e., a primary alcohol) to a carboxyl group. In both cases, there are two molecules of pyridine nucleotide required, and the overall reactions are essentially irreversible. The former enzyme, with A stereospecificity for the pyridine nucleotide, catalyzes the reduction of an acyl-CoA group... 

A better reagent for oxidation of primary alcohols to aldehydes in good yield is pyridinium chlorochromate (PCC), a complex of chromium trioxide with pyridine and HCl. 

Reduction of the carboxylic acid group passes through the intermediate aldehyde. For a number of examples in the heterocyclic series, the aldehyde becomes a major product because it is trapped as the hydrated vfc.-diol form. Examples include imidazole-2-caiboxylic acid [139], thiazole-2-carboxylic acid [140] and pyridine-4-carboxylic acid [141] reduced in dilute aqueous acid solution. Reduction of imidazole-4-carboxylic acid proceeds to the primary alcohol stage, the aldehyde intermediate is not isolated. Addition of boric acid and sodium sulphite to the electrolyte may allow the aldehyde intermediate to be trapped as a non-reducible complex, Salicylaldehyde had been obtained on a pilot plant scale in this way by... 

The next phase focused on the goal of elaboration of the side chain in the desired sense. The primary alcohol function at C7 was unveiled by hydrogenolysis (Pd(OH)2/EtOAc-MeOH). Oxidation of the resultant compound 13 with chromic oxide pyridine afforded aldehyde 14, which was now to be elongated through some variation of a Homer-Emmons type of reaction. Shortly before tiiese investigations were launched. Still had demonstrated the use of phosphonate 15 as a device to achieve the two-carbon extension of an aldehyde to a Z-enoate (12). Happily, application of the Still method to compound 14 afforded the desired 16, mp 120-121° C, in 80% yield as a 20 1 mixture of Z E enoates. 

The ready condensation of sucrose with excess triphenylmethyl chloride in pyridine to a tri-trityl ether is, however, more easily explained by XV or II, which have three, instead of two (c/. I), primary alcohol groups to react selectively in the condensation. Fleury and Courtois oxidized sucrose for twenty-four hours at 14° with an excess of suitably buffered periodic acid and found that three moles of the oxidant were consumed and one mole of formic acid was eliminated. This highly selective oxidant is known to cleave unsubstituted 1,2 glycols quantitatively to two carbonyl groups and to eliminate the center carbon atom... 

Tertiary benzylic nitriles are useful synthetic intermediates, and have been used for the preparation of amidines, lactones, primary amines, pyridines, aldehydes, carboxylic acids, and esters. The general synthetic pathway to this class of compounds relies on the displacement of an activated benzylic alcohol or benzylic halide with a cyanide source followed by double alkylation under basic conditions. For instance, 2-(2-methoxyphenyl)-2-methylpropionitrile has been prepared by methylation of (2-methoxyphenyl)acetonitrile using sodium amide and iodomethane. In the course of the preparation of a drug candidate, the submitters discovered that the nucleophilic aromatic substitution of aryl fluorides with the anion of a secondary nitrile is an effective method for the preparation of these compounds. The reaction was studied using isobutyronitrile and 2-fluoroanisole. The submitters first showed that KHMDS was the superior base for the process when carried out in either THF or toluene (Table I). For example, they found that the preparation of 2-(2-methoxyphenyl)-2-methylpropionitrile could be accomplished h... 

---