Pressure distribution hydrodynamic effect

Even in this extreme condition, a very thin film still remains under flow to keep the surfaces apart. This means that something more exists in addition to hydrodynamic theory. EHD film formation depends on the coupled effects of physical property changes of the lubricants at high pressure and elastic changes in the shape of the solids about the contact area, which fect the pressure distribution. The high pressure in the EHD contact area increases the viscosity of lubricants enormously. 

Two-phase flows are classified by the void (bubble) distributions. Basic modes of void distribution are bubbles suspended in the liquid stream liquid droplets suspended in the vapor stream and liquid and vapor existing intermittently. The typical combinations of these modes as they develop in flow channels are called flow patterns. The various flow patterns exert different effects on the hydrodynamic conditions near the heated wall thus they produce different frictional pressure drops and different modes of heat transfer and boiling crises. Significant progress has been made in determining flow-pattern transition and modeling. 

Fitzgerald et al. (1984) measured pressure fluctuations in an atmospheric fluidized bed combustor and a quarter-scale cold model. The full set of scaling parameters was matched between the beds. The autocorrelation function of the pressure fluctuations was similar for the two beds but not within the 95% confidence levels they had anticipated. The amplitude of the autocorrelation function for the hot combustor was significantly lower than that for the cold model. Also, the experimentally determined time-scaling factor differed from the theoretical value by 24%. They suggested that the differences could be due to electrostatic effects. Particle sphericity and size distribution were not discussed failure to match these could also have influenced the hydrodynamic similarity of the two beds. Bed pressure fluctuations were measured using a single pressure point which, as discussed previously, may not accurately represent the local hydrodynamics within the bed. Similar results were... 

The hydrodynamic factors that influence the plasma polymerization process pose a complicated problem and are of importance in the application of plasma for thin film coatings. When two reaction chambers with different shapes or sizes are used and when plasma polymerization of the same monomer is operated under the same operational conditions of RF power, monomer flow rate, pressure in the reaction chamber etc., the two plasma polymers formed in the two reaction chambers are never identical because of the differences in the hydrodynamic factors. In this sense, plasma polymerization is a reactor-dependent process. Yasuda and Hirotsu [22] systematically investigated the effects of hydrodynamic factors on the plasma polymerization process. They studied the effect of the monomer flow pattern on the polymer deposition rate in a tubular reactor. The polymer deposition rate is a function of the location in the chamber. The distribution of the polymer deposition rate is mainly determined by the distance from the plasma zone and the... 

Ion Exchange Chromatography This application can embrace a resin particle size from around 700 /x.m down to less than 10 /x.m. Deep Resin Beds A requirement for a narrow size distribution and sufficiently large effective size to minimize hydrodynamic pressure losses. 

The areas concerned with hydrodynamics in trickle beds include flow regimes, liquid distribution on the solid (catalyst) packing, pressure drop, liquid holdup, and, more generally, the effect of the physical properties of the liquid and gas phases on all hydrodynamic properties. 

---