Pressure cartridge

PC12 Pressure cartridge HS Zr/KC104/Si rubber Zr/KC104 12... 

Commercial St, San Carlos, Calif, 94070 Quoted from Expis Pyrots 2(11)(1969) (A new family of initiators has a microcircuit bridge, is at least one-amp, one-watt no fire, is hermetically sealed and heat sterilizable to 500°F. Pressure cartridges and gas generators are also available. Data sheets include description, drawing, design data and environmental specs met D) Collective, Electroexplosive Devices , Proceedings of the Sixth Symposium on Electroexplosive Devices, held in San Francisco, Calif,... 

An interdigital slit-type high-pressure micromixer followed by a tube (0.9 mm inner diameter 2.6 m long) was used [48]. The micromixer-tube reactor was submersed into a thermostat bath for temperature setting. HPLC pumps fed the monomer and initiator flows. A back-pressure cartridge (70 bar) and a pressure sensor served for pressure control. The temperature was set to 105 °C. The processing protocol was carried out conventionally, using the specs of similar batch processes. 

With compressed air With compressed air with over pressure cartridge... 

NMP of styrene and /i-butyl acrylate at 140°C has been performed in a continuous-flow microtubular reactor (Fig. 27) consisting of a stainless steel tube reactor and a back-pressure cartridge [212]. In the case of styrene polymerization, there is no difference between batch reactors and flow microreactors. However, for M-butyl acrylate, a better control of the polymerization has been observed in the flow microreactor (A/w/A/ of 1-80 for the batch reactor and 1.44 for the flow microreactor). Moreover, consumption of the monomer is much faster using the flow microreactor (Fig. 28). 

Fire extingnishers exist in three basic operating designs according to NFPA 10. They are stored pressure, cartridge operated, and self-expelling. This refers to the... 

Solder Paste Printing Increased print pressure and slower print speed Double print stroke Pressurized cartridge... 

---