Polymer samples, characterization silica

This is an effective and relatively simple method for characterizing silica sols and other colloids [75]. It has also been used to determine the particle size distributions of polymer lattices [76,77]. Separations are performed in a column packed with particles having pores substantially of the same size. A carrier liquid is passed through the column as a mixture of colloidal particles passes through the bed, the larger ones exit first since they are too large to sample the pore volume. Intermediate sized colloids enter the pores and are retained according to the volume that can be... 

To determine the size of unknown silica sols with relatively narrow distributions, the retention time of the band for an unknown sample is compared to a peak-position calibration plot such as that shown in Figure 9. Just as for the determination of molecular weight for polymers, broad distributions of silica sols can be measured with appropriate software by using known calibration methods involving peak positions or by using known standards with broad distributions (26). However, commercial software for specifically characterizing silica sols and other colloids is apparently not yet available. 

Figure 12.8 Mia ocolumn size exclusion chromatogram of a styrene-aaylonitrile copolymer sample fractions ti ansfeired to the pyrolysis system are indicated 1-6. Conditions fused-silica column (50 cm X 250 p.m i.d.) packed with Zorbax PSM-1000 (7p.m 4f) eluent, THF flow rate, 2.0 p.L/min detector, Jasco Uvidec V at 220 nm injection size, 20 nL. Reprinted from Analytical Chemistry, 61, H. J. Cortes et al, Multidimensional chromatography using on-line microcolumn liquid chromatography and pyrolysis gas chromatography for polymer characterization , pp. 961 -965, copyright 1989, with peimission from the American Chemical Society.

There are several major areas of interfacial phenomena to which infrared spectroscopy has been applied that are not treated extensively in this volume. Most of these areas have established bodies of literature of their own. In many of these areas, the replacement of dispersive spectrometers by FT instruments has resulted in continued improvement in sensitivity, and in the interpretation of phenomena at the molecular level. Among these areas are the characterization of polymer surfaces with ATR (127-129) and diffuse reflectance (130) sampling techniques transmission IR studies of the surfaces of powdered samples with adsorbed gases (131-136) alumina(137.138). silica (139). and catalyst (140) surfaces diffuse reflectance studies of organo- modified mineral and glass fiber surfaces (141-143) metal overlayer enhanced ATR (144) and spectroelectrochemistry (145-149). 

In the last years large attention was devoted to the synthesis and characterization of SBA-16 material focusing the interest on the formation mechanisms of copolymer micelles which drive the organization of the final siliceous mesostructure. In this framework, the physico-chemical properties at the interface between silica and triblock E0106P070E0106 co-polymer in a SBA-16 material were investigated. In particular, the combination of IR spectroscopy with SS NMR allowed to obtain complementary information on how the surfactant co-polymer interacts with the SBA-16 surface silanols in the presence or absence of physisorbed water and to follow the evolution of the structural organization of the co-polymer, which depends on the hydration degree of the SBA-16 sample. 

---