Polyfurans

Polypyrrole, poly thiophene, polyfuran, polycarbazole, polystyrene with tetrathi-afulvalene substituents, polyethylene with carbazole substituents, and poly-oxyphenazine as electrochemically active polymers for rechargeable batteries 97CRV207. 

Fig. 1 Building units of conducting polymers, (1) polyacetylene (PA) (2) polypyrrole (PPy), polythiophene (PTh), polyfurane (PFu) (3) polyphenylene (PP) (4) polyaniline (PANI) 5 polyindole (PIND) (6) polycarbazole (PCaz) (7) polyazulene (Paz) (8) polynaphthalene (PNa) (9) polyanthracene (PAnth) (10) polypyrene (PPyr) (11) polyfluorene (PFiu) (12) poly(isothionaphthalene) (PITN) (13) poly(dithienothiophene) (14) poly(thienopyrrole) (15) poly(dithienylbenzene) (1G) poly(3-alkylthiophene) (17) poly(phenylene vinylene) (18) poly(bipyrrole) (PBPy), poly(bithiophene) (PBT) (19) poly(phenylenesulfide) (20) 4-poly(thienothiophene) (21) poly(thienyl vinylene), poly(furane vinylene) (22) poly(ethylenedioxythiophene) (PEDOT).

While oxidation of furan yields ill-defined polymers with severely interrupted Jt-conjugation, oxidation of 2,2, 5, 2"-terfuran 1 ( = 3) does produce fully jt-conjugated polyfuran films. These films, when doped with tri-fluoromethanesulfonate ions, exhibit conductivities of up to 2 x lO Scm and a gap of 2.35 eV between the... 

Strength, fire resistance and apparent density of polyfuran foams depend on the composition of the mixture, amount and type of filler. By varying these parameters, foamed materials may be obtained with 7 = 20-100 kg/m or higher. The fire resistance of these materials is better than that of foamed phenoplastics and polyiso-cyanurate foams, and the mechanical strength is higher than that of carbamide foams. 

The solution coating technique was used in the preparation of the cellulose triacetate membrane discussed above. A solution of cellulose triacetate in chloroform was deposited on the porous support and the solvent was then evaporated leaving a thin film on the porous support. Thin film polymerization was used to prepare a polyfuran membrane barrier layer on polysulfone. In this case, the monomer furfuryl alcohol is polymerized in situ by adjustment of pH and temperature. This membrane proved to be highly susceptible to oxidizing agents and is of limited value. By far the most valuable technique in the formation of membrane barrier layers is interfacial polycondensation. In this method, a polymer is formed on the porous support surface at the interface of organic and aqueous phases by reaction of specific molecules dissolved in each phase. It is by this method that a number of polyamides and polyurea membrane barrier layers have been formed on polysulfone. Elements containing these membranes are available commercially. 

---