Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Polyesters, thermoplastic, warpage

In injection molding of semicrystalline thermoplastics, for example polyamide, polyoxymethylene, ultrahigh molecular polyethylene (very high melt viscosity), linear polyesters (PET, PBT), local variations in molecular orientation result in dimensional variations in the part (warpage, memory effect), especially if the toothed gear is exposed to a thermal stress load. [Pg.340]

Description Aminosilane surface-treated grades, giving improvements in physical properties compared with untreated fillers, esp. low warpage, high impact strength specially developed for mineral-filled polyamides can also be used in polyesters, urethane, PVC and other thermoplastics white colour ... [Pg.377]

The tendency of thick sections of DMC structural parts to crack has been overcome by using low-profile polyester resins (or low-shrink resins). These are prepared by making a blend of a thermoplastic (e.g., acrylic) polymer-styrene system with a polyester-styrene system. Moldings of this blend cured at elevated temperatures exhibit negligible shrinkage and minimal warpage and have very smooth surface, to which paint may be applied with very little pretreatment. [Pg.81]


See other pages where Polyesters, thermoplastic, warpage is mentioned: [Pg.160]    [Pg.320]    [Pg.320]    [Pg.333]    [Pg.194]    [Pg.444]    [Pg.264]    [Pg.328]    [Pg.328]    [Pg.1651]    [Pg.6158]    [Pg.510]    [Pg.9]    [Pg.380]    [Pg.677]    [Pg.444]   
See also in sourсe #XX -- [ Pg.380 ]




SEARCH



Polyesters thermoplastic polyester

Thermoplastic polyesters

© 2024 chempedia.info