Plotted curve attributes

The inherent limitations of attribute data prevent their use for preliminary statistical studies since specification values are not measured. Attribute data have only two values (conforming/nonconforming, pass/fail, go/no-go, present/absent) but they can be counted, analyzed, and the results plotted to show variation. Measurement can be based on the fraction defective, such as parts per million (PPM). While variables data follows a distribution curve, attribute data varies in steps since you can t count a fraction. There will either be zero errors or a finite number of errors. 

Examination of the effect of pH on the rates of protodeboronation of the 2,6-dimethoxy compound at 90 °C in malonic acid-sodium malonate buffer solutions of ionic strength 0.14 gave the data in Table 199. A plot of these data revealed the curve shown in Fig. 3 (one of the points was misplotted on the original) and the linear portions of the plot were attributed to acid and base catalysis as shown on Fig. 3, and since the rates in the region of pH 4-5 are higher than would be... 

When the data in Fig. 5 is plotted according to this relation (i.e. t/(C - C) vs t) a straight line is obtained (see Fig. 6) with only slight curature at low values of t where a first order plot (log C vs t) shows a reasonable straight line. Similar early curvature (56) in analogous plots was attributed to the time required for temperature equilibration. This is opposite to what is expected here since the concentration - time curve indicates a rapid drop in concentration in the early stages rather than a slower decay rate. 

The behaviour [821] of AgN02 is closer to that expected of a nitro compound than a nitrite. Decomposition (308—363 K) yields Ag metal and N02. a—Time curves are sigmoid with a prominent linear region (0.15 < a < 0.45) but the Arrhenius plot was curved at >333 K. This was attributed to inadequate gaseous product removal. In contrast to the behaviour observed for most other solids, pre-irradiation with 7-rays inhibits subsequent thermal decomposition [829]. 

In Figure 4 we have presented the experimental Tafel plots of air electrodes with catalysts from pure active carbon and from active carbon promoted with different amounts of silver. The obtained curves are straight lines with identical slopes. It must be underlined that the investigated electrodes possess identical gas layers and catalytic layers, which differ in the type of catalyst used only. Therefore, the differences in the observed Tafel plots can be attributed to differences in the activity of the catalysts used. The current density a at potential zero (versus Hg/HgO), obtained from the Tafel plots of the air electrodes is accepted as a measure of the activity of the air gas-diffusion electrodes the higher value of a corresponds to higher activity of the air electrode. 

Rate measurements are straightforward if the carbenes can be monitored directly. As a rule, the decay of carbene absorption is (pseudo) first-order, due to rearrangement and/or reaction with the solvent. In the presence of a quencher, the decay is accelerated (Eq. 1), and the rate constant kq is obtained from a plot of k0bs versus [Q], Curved plots were often observed with proton donors (HX) as quenchers, particularly for high concentrations of weakly acidic alcohols. Although these effects have been attributed to oligomerization of the alcohols,91 the interpretation of curved plots remains a matter of dispute.76 Therefore, the rate constants reported in Tables 2-4 are taken from linear (regions of) obs-HX plots, or refer to a specified concentration of HX. 

---