Plate liquid chromatography

High-Performance liquid Chromatography. Typical performances for various experimental conditions are given in Table 11.15. The data assume these reduced parameters h = 3, V = 4.5. The reduced plate height is... 

Why is liquid chromatography a less efficient separation technique, as measured by the number of theoretical plates per column, than gas chromatography ... 

One of the most complex separation schemes utilizes flash liquid chromatography and PLC to obtain petropophyrins both from geochemical samples or those synthesized and used subsequently as standards [110]. Ocampo and Repeta [111] described the scheme of petroporphyrins isolation in which at the first step the sediment extract is fractionated into ten fractions on silica gel using dichlo-romethane (fractions 1 to 4), a mixture of dichloromethane-acetone with increasing acetone concentrations (for fractions 5 to 9), and, at last, dichlo-romethane methanol (4 1) (fraction 10). Next, the fifth fraction was separated on silica PLC plates using dichloromethane-acetone (97.5 2.5 v v v) as a developer. Two purple bands (with Rj 0.53 and 0.50) were recovered from silica and purified further on a silica gel column with dichloromethane-acetone (97.5 2.5, v v v) as an eluent. The emiched fraction was then separated by PLC with the same solvent mixture, and the purple bands containing two bacteriopheophytin allomers were recovered with acetone. 

Kirkland, J. J., Yau, W. W., Stoklosa, H. J., and Dilks Jr., C. H., Sampling and extra-column effects in high-performance liquid chromatography influence of peak skew on plate count calculations, /. Chromatogr. Sci., 15, 303, 1977. 

Fig. 3. Diagrams of electrochemical cells used in flow systems for thin film deposition by EC-ALE. A) First small thin layer flow cell (modeled after electrochemical liquid chromatography detectors). A gasket defined the area where the deposition was performed, and solutions were pumped in and out though the top plate. Reproduced by permission from ref. [ 110]. B) H-cell design where the samples were suspended in the solutions, and solutions were filled and drained from below. Reproduced by permission from ref. [111]. C) Larger thin layer flow cell. This is very similar to that shown in 3A, except that the deposition area is larger and laminar flow is easier to develop because of the solution inlet and outlet designs. In addition, the opposite wall of the cell is a piece of ITO, used as the auxiliary electrode. It is transparent so the deposit can be monitored visually, and it provides an excellent current distribution. The reference electrode is incorporated right in the cell, as well. Adapted from ref. [113],...

---