Plastic range, drying methods

Often the OEM coatings depend on the nature and condition of the substrate to which paint is applied application methods and conditions drying time required and decorative and protective requirements. The substrate most commonly coated with industrial coatings are iron and steel, but also include other metals such as aluminum and its alloys, zinc-coated steel, brass, bronze, copper, and lead. Nonmetalhc substrates include timber and timber products, concrete, cement, glass, ceramics, fabric, paper, leather, and a wide range of different plastic materials. Consequently, industrial coatings are usually formulated for use on either a specific substrate or a group of substrates. 

Offset printing Roll-transfer method of decorating. In most cases less expensive than other multicolor printing methods. Ranges from low-cost hand presses to very expensive automated units. Drying, destaticizers, feeding devices. Most plastics. Used in applications like coding pipe. Multicolor print or decoration. 

All of the 23 plasticizers in Table 18.1 occur as viscous or oily liquids that range from colorless to an amber color. If these liquids were spilled on soil or sediments, a portion of the liquid could volatilize into the air, depending on the specific compound, but most of the 23 plasticizers have vapor pressures that are less than 10 mm Hg at 25°C (Table 18.13). The vapor pressures of nine of the compounds have not been measured. For these plasticizers, vapor pressures were estimated using the Fragment Constant Method. As noted earlier, most of these chemicals will also be adsorbed by soil and sediments which would reduce the extent of volatiUzation. The rate of volatilization of plasticizers from soil has not been measured. For the purpose of illustration, the Dow Method was applied to estimate the half-life of each plasticizer if it was spilled on the surface of a dry soil. The Dow Method is a simple relationship that was derived for the evaporation of pesticides from bare soil ... 

---