Palladium methanation reaction

Carbon-carbon bond formation reactions and the CH activation of methane are another example where NHC complexes have been used successfully in catalytic applications. Palladium-catalysed reactions include Heck-type reactions, especially the Mizoroki-Heck reaction itself [171-175], and various cross-coupling reactions [176-182]. They have also been found useful for related reactions like the Sonogashira coupling [183-185] or the Buchwald-Hartwig amination [186-189]. The reactions are similar concerning the first step of the catalytic cycle, the oxidative addition of aryl halides to palladium(O) species. This is facilitated by electron-donating substituents and therefore the development of highly active catalysts has focussed on NHC complexes. 

Reaction between carbon monoxide and dihydrogen. The catalysts used were the Pd/Si02 samples described earlier in this paper. The steady-state reaction was first studied at atmospheric pressure in a flow system (Table II). Under the conditions of this work, selectivity was 100% to methane with all catalysts. The site time yield for methanation, STY, is defined as the number of CH molecules produced per second per site where the total number of sites is measured by dihydrogen chemisorption at RT before use, assuming H/Pd = 1. The values of STY increased almost three times as the particle size decreased. The data obtained by Vannice et al. (11,12) are included in Table II and we can see that the methanation reaction on palladium is structure-sensitive. It must also be noted that no increase of STY occurred by adding methanol to the feed stream which indicates that methane did not come from methanol. 

A new type of triaryl phosphine-functionalized imidazolium salt containing cations such as (6) has been prepared. Palladium complexes of (6) generated in situ have been used successfully in Heck-type reactions of aryl halides with acrylates and of 4-bromotoluene with styrene derivatives.34 The first Heck-type reaction of aryl halides with allenes has been reported. 1,3-Double arylations were observed with 3-substituted-l,2-allenyl sulfones, while 1-monoarylation was favoured with 3,3-disubstituted-l,2-allenyl sulfones.35 It has been shown that the a-arylation of methane-sulfonamides (7) may be achieved using palladium catalysis reaction proceeds through the sulfonamide enolates.36 It is also reported that palladium cross-coupling of alkynes with /V - (3 - i odophe n y I an i I i ncs) may lead to the formation of substituted carbazoles.37... 

Irrespective of the nature of the reaction intermediate, enolic type (11) or surface carbide (12), the dechne of the turnover number for the zeolites with higher Si/Al ratio can be explained as follows. For platinum (13) and palladium (14,15) loaded zeolites, support effects are known to exist. The higher the acidity (and the oxidizing power) of the zeolite, the higher will be the electron-deficient character of the supported metal. It also is well established now (16) that the average acidity of hydrogen zeohtes increases with the Si/Al ratio. This explains why the electron deficient character of ruthenium should increase with the Si/Al ratio of the zeolite, and a stronger interaction with adsorbed CO should be expected. Vannice (19,20) reported that the N value for CH4 formation decreases when the heat of adsorption for CO increases. All this explains why the tmnover number of the methanation reaction over ruthenium decreases when the Si/Al ratio of the zeolite support increases. 

Figure 3.19 Synthesis and reactions of palladium(I) bis(diphenylphosphino)methane complexes.

Palladium on a purified activated carbon support has been selected as a very suitable catalyst for the reaction. We have reported that the performance of this catalyst looks very promising and that a CFC hydrogenolysis plant based on this catalyst is both technically and economically feasible [3-5]. This paper deals with the stability of the selected catalyst, the long term influence of the hydrogen to CCI2F2 feed ratio on the catalyst performance and the influence of the possible recycle components methane and CHCIF2 on the performance of the catalyst. 

The mechanism for the reaction catalyzed by cationic palladium complexes (Scheme 24) differs from that proposed for early transition metal complexes, as well as from that suggested for the reaction shown in Eq. 17. For this catalyst system, the alkene substrate inserts into a Pd - Si bond a rather than a Pd-H bond [63]. Hydrosilylation of methylpalladium complex 100 then provides methane and palladium silyl species 112 (Scheme 24). Complex 112 coordinates to and inserts into the least substituted olefin regioselectively and irreversibly to provide 113 after coordination of the second alkene. Insertion into the second alkene through a boat-like transition state leads to trans cyclopentane 114, and o-bond metathesis (or oxidative addition/reductive elimination) leads to the observed trans stereochemistry of product 101a with regeneration of 112 [69]. 

Addition of disilanes to isocyanides is catalyzed by palladium complexes, giving A-substituted bis(silyl)imino-methanes (Equation (53)).132 A wide range of isocyanides including aryl isocyanides and alkyl isocyanides can take part in the reaction. However, it is important to note that tert-alkyl isocyanides hardly undergo the bis-silylation reaction. This low reactivity of / r/-alkyl isocyanides allows their use as spectator ligands in the catalytic bis-silylations. 

---