Palladium complexes reductive elimination

Some nucleophiles (organometallics RM and hydride equivalents, featuring very weak conjugate acids) show a different stereochemical outcome, the attack of the nucleophile taking place at the palladium atom to form a neutral rj3 complex. Reductive elimination—or, in other words, intramolecular delivery of the nucleophile to the allylic framework—occurs with retention of configuration. In short, the reactions with these types of nucleophiles occur with overall inversion (inversion + retention) of configuration. 

A chelation-assisted mthenium-catalyzed arylation of aldehyde 99 was accomplished in combination with a palladium complex [47]. This cooperative catalysis [48] proved applicable to organostannanes and aryl iodides as arylating reagents (Scheme 9.35). The direct arylation proceeded most likely through ruthenium-catalyzed C—H bond activation, subsequent transmetallation to palladium, and reductive elimination from a palladium intermediate. 

Homocoupling likely occurs by a related catalytic cycle, but less information is known about this process. A nickel(O) or palladium(O) complex undergoes oxidative addition of an aryl halide. One could imagine that a second aryl halide adds to generate an intermediate in the M(IV) oxidation state, but this step is unlikely to occur with either palladium or nickel catalysts. One can also envision a mechanism involving disproportionation of the arylmetal-halide intermediate to form a biaryl complex and a dihalide complex. Reductive elimination would form the biaryl, and reduction of the dihalide with Zn or other terminal reductant would regenerate the catalyst. 

Based on the above-mentioned stereochemistry of the allylation reactions, nucleophiles have been classified into Nu (overall retention group) and Nu (overall inversion group) by the following experiments with the cyclic exo- and ent/n-acetales 12 and 13[25], No Pd-catalyzed reaction takes place with the exo-allylic acetate 12, because attack of Pd(0) from the rear side to form Tr-allyl-palladium is sterically difficult. On the other hand, smooth 7r-allylpalladium complex formation should take place with the endo-sWyWc acetate 13. The Nu -type nucleophiles must attack the 7r-allylic ligand from the endo side 14, namely tram to the exo-oriented Pd, but this is difficult. On the other hand, the attack of the Nu -type nucleophiles is directed to the Pd. and subsequent reductive elimination affords the exo products 15. Thus the allylation reaction of 13 takes place with the Nu nucleophiles (PhZnCl, formate, indenide anion) and no reaction with Nu nucleophiles (malonate. secondary amines, LiP(S)Ph2, cyclopentadienide anion). 

Dehalogenation of monochlorotoluenes can be readily effected with hydrogen and noble metal catalysts (34). Conversion of -chlorotoluene to Ncyanotoluene is accompHshed by reaction with tetraethyl ammonium cyanide and zero-valent Group (VIII) metal complexes, such as those of nickel or palladium (35). The reaction proceeds by initial oxidative addition of the aryl haHde to the zerovalent metal complex, followed by attack of cyanide ion on the metal and reductive elimination of the aryl cyanide. Methylstyrene is prepared from -chlorotoluene by a vinylation reaction using ethylene as the reagent and a catalyst derived from zinc, a triarylphosphine, and a nickel salt (36). 

It was found [99JCS(PI )3713] that, in all cases, the formation of the deiodinated products 38 and 39 was accompanied by formation of the diynes 40 which were isolated in 60-90% yield. The authors believed that the mechanism of deiodination may be represented as an interaction ofbis(triphenylphosphine)phenylethynyl-palladium(II) hydride with the 4-iodopyrazole, giving rise to the bisftriphenylphos-phine)phenylethynyl palladium(II) iodide complex which, due to the reductive elimination of 1 -iodoalkyne and subsequent addition of alk-1 -yne, converts into the initial palladium complex. Furthermore, the interaction of 1-iodoalkynes with the initial alkyne in the presence of Cul and EtsN (the Cadiot-Chodkiewicz reaction) results in the formation of the observed disubstituted butadiynes 40 (Scheme 51). 

The mechanism of action of the cyanation reaction is considered to progress as follows an oxidative addition reaction occurs between the aryl halide and a palladium(O) species to form an arylpalladium halide complex which then undergoes a ligand exchange reaction with CuCN thus transforming to an arylpalladium cyanide. Reductive elimination of the arylpalladium cyanide then gives the aryl cyanide. 

Reductive elimination—to yield the coupling product 3 and regeneration of the catalytically active palladium-(O) complex 5. 

The postulated steps that constitute the Suzuki coupling process are shown in Scheme 25. After oxidative addition of the organic halide to the palladium(o) catalyst, it is presumed that a metathetical displacement of the halide substituent in the palladium(ii) complex A by ethoxide ion (or hydroxide ion) takes place to give an alkoxo-palladium(ff) complex B. The latter complex then reacts with the alkenylborane, generating the diorganopalladium complex C. Finally, reductive elimination of C furnishes the cross-coupling product (D) and regenerates the palladium(o) catalyst. 

In the direct coupling reaction (Scheme 30), it is presumed that a coordinatively unsaturated 14-electron palladium(o) complex such as bis(triphenylphosphine)palladium(o) serves as the catalytically active species. An oxidative addition of the organic electrophile, RX, to the palladium catalyst generates a 16-electron palladium(n) complex A, which then participates in a transmetalation with the organotin reagent (see A—>B). After facile trans- cis isomerization (see B— C), a reductive elimination releases the primary organic product D and regenerates the catalytically active palladium ) complex. 

Palladium(II) complexes provide convenient access into this class of catalysts. Some examples of complexes which have been found to be successful catalysts are shown in Scheme 11. They were able to get reasonable turnover numbers in the Heck reaction of aryl bromides and even aryl chlorides [22,190-195]. Mechanistic studies concentrated on the Heck reaction [195] or separated steps like the oxidative addition and reductive elimination [196-199]. Computational studies by DFT calculations indicated that the mechanism for NHC complexes is most likely the same as that for phosphine ligands [169], but also in this case there is a need for more data before a definitive answer can be given on the mechanism. 

The palladium(O) complex undergoes first an oxydative addition of the aryl halide. Then a substitution reaction of the halide anion by the amine occurs at the metal. The resulting amino-complex would lose the imine with simultaneous formation of an hydropalladium. A reductive elimination from this 18-electrons complex would give the aromatic hydrocarbon and regenerate at the same time the initial catalyst. 

The coupling of terminal alkynes with aryl or alkenyl halides catalysed by palladium and a copper co-catalyst in a basic medium is known as the Sonogashira reaction. A Cu(I)-acetylide complex is formed in situ and transmetallates to the Pd(II) complex obtained after oxidative addition of the halide. Through a reductive elimination pathway the reaction delivers substituted alkynes as products. 

The mechanism involves a Pd(0) monocoordinate complex as the active species that undergoes oxidative addition to the aryl halide [141]. Thereafter, coordination of the amine to the palladium centre and deprotonation by the external base results in halide abstraction. After reductive elimination, the coupling product is obtained and the catalytic active species regenerated (Scheme 6.45). 

Kurosawa et al. have reported that the relative stability of the ti-allyl palladium thi-olate 39 and the allyl sulfide/Pd(0) was highly ligand dependent. In the presence of PPhs or P(OMe)3 the stability was in favor of reductive elimination (Eq. 7.28), while in the presence of olefin or in the absence of any additional ligand the stability was in favor of oxidative addition (Eq. 7.29) [38]. This can explain the reactivity of the n-allyl palladium thiolate 33 and 38 proposed in Eq. (7.24) and path (c) of Scheme 7-10. The complex 33 should react with PhSH, but C-S bond-forming reductive elimination has to be suppressed in order to obtain the desired product 32. On the other hand, the complex 38 requires the phosphine ligand to promote the C-S bond-forming reductive elimination. 

Some of the details of the mechanism may differ for various catalytic systems. There have been kinetic studies on two of the amination systems discussed here. The results of a study of the kinetics of amination of bromobenzene using Pd2(dba)3, BINAP, and sodium r-amyloxide in toluene were consistent with the oxidative addition occurring after addition of the amine at Pd. The reductive elimination is associated with deprotonation of the animated palladium complex.166... 

The mechanism for the reaction catalyzed by cationic palladium complexes (Scheme 24) differs from that proposed for early transition metal complexes, as well as from that suggested for the reaction shown in Eq. 17. For this catalyst system, the alkene substrate inserts into a Pd - Si bond a rather than a Pd-H bond [63]. Hydrosilylation of methylpalladium complex 100 then provides methane and palladium silyl species 112 (Scheme 24). Complex 112 coordinates to and inserts into the least substituted olefin regioselectively and irreversibly to provide 113 after coordination of the second alkene. Insertion into the second alkene through a boat-like transition state leads to trans cyclopentane 114, and o-bond metathesis (or oxidative addition/reductive elimination) leads to the observed trans stereochemistry of product 101a with regeneration of 112 [69]. 

---