Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Optical modes, vibration

If a diffusional model with AHm < kT is appropriate, then the time th between electron hops must approach the period cor of the optical mode vibrations that trap or correlate the electrons. With an wj = 10" s, the hopping time Th would be short relative to the time scale of Mossbauer spectroscopy, ca. 10" s. We can therefore anticipate an isomer shift for the octahedral-site iron that is midway between the values typical for Fe ions and Fe " " ions. From Table 1 and Eq. (1), we can predict a room-temperature isomer shift of 6 0.75 mm/s wrt iron. Consistent with this prediction is the... [Pg.22]

The normal modes for solid Ceo can be clearly subdivided into two main categories intramolecular and intermolecular modes, because of the weak coupling between molecules. The former vibrations are often simply called molecular modes, since their frequencies and eigenvectors closely resemble those of an isolated molecule. The latter are also called lattice modes or phonons, and can be further subdivided into librational, acoustic and optic modes. The frequencies for the intermolecular modes are low, reflecting, the... [Pg.52]

Abstract The self-organized and molecularly smooth surface on liquid microdroplets makes them attractive as optical cavities with very high quality factors. This chapter describes the basic theory of optical modes in spherical droplets. The mechanical properties including vibrational excitation are also described, and their implications for microdroplet resonator technology are discussed. Optofluidic implementations of microdroplet resonators are reviewed with emphasis on the basic optomechanical properties. [Pg.471]

Close to this limit the displacements of the two types of atom have opposite sign and the two types of atom vibrate out of phase, as illustrated in the lower part of Figure 8.10. Thus close to q = 0, the two atoms in the unit cell vibrate around their centre of mass which remains stationary. Each set of atoms vibrates in phase and the two sets with opposite phases. There is no propagation and no overall displacement of the unit cell, but a periodic deformation. These modes have frequencies corresponding to the optical region in the electromagnetic spectrum and since the atomic motions associated with these modes are similar to those formed as response to an electromagnetic field, they are termed optical modes. The optical branch has frequency maximum at q = 0. As q increases slowly decreases and... [Pg.239]

Kieffer has estimated the heat capacity of a large number of minerals from readily available data [8], The model, which may be used for many kinds of materials, consists of three parts. There are three acoustic branches whose maximum cut-off frequencies are determined from speed of sound data or from elastic constants. The corresponding heat capacity contributions are calculated using a modified Debye model where dispersion is taken into account. High-frequency optic modes are determined from specific localized internal vibrations (Si-O, C-0 and O-H stretches in different groups of atoms) as observed by IR and Raman spectroscopy. The heat capacity contributions are here calculated using the Einstein model. The remaining modes are ascribed to an optic continuum, where the density of states is constant in an interval from vl to vp and where the frequency limits Vy and Vp are estimated from Raman and IR spectra. [Pg.247]

Figure 8.16 (a) IR and (b) Raman spectra for the mineral calcite, CaC03. The estimated density of vibrational states is given in (c) while the deconvolution of the total heat capacity into contributions from the acoustic and internal optic modes as well as from the optic continuum is given in (d). [Pg.248]

I he notation 0e indicates that this is the dielectric function at frequencies low i ompared with electronic excitation frequencies. We have also replaced co0 with l (, the frequency of the transverse optical mode in an ionic crystal microscopic theory shows that only this type of traveling wave will be readily excited bv a photon. Note that co2 in (9.20) corresponds to 01 e2/me0 for the lattice vibrations (ionic oscillators) rather than for the electrons. The mass of an electron is some thousands of times less than that of an ion thus, the plasma liequency for lattice vibrations is correspondingly reduced compared with that lor electrons. [Pg.241]

The fact that the order parameter vanishes above does not mean that Nature does not have an inkling of things to come well below (or above) T. Such indicators are indeed found in many instances in terms of the behaviour of certain vibrational modes. As early as 1940, Raman and Nedungadi discovered that the a-) transition of quartz was accompanied by a decrease in the frequency of a totally symmetric optic mode as the temperature approached the phase transition temperature from below. Historically, this is the first observation of a soft mode. Operationally, a soft mode is a collective excitation whose frequency decreases anomalously as the transition point is reached. In Fig. 4.4, we show the temperature dependence of the soft-mode frequency. While in a second-order transition the soft-mode frequency goes to zero at T, in a first-order transition the change of phase occurs before the mode frequency is able to go to zero. [Pg.173]

In eq. (6) the two atoms in the unit cell vibrate in phase as in an acoustic mode, while in eq. (7) the two atoms in the unit cell vibrate in antiphase so that it is called an optic mode. [Pg.408]

By comparing the resonance frequency Eq.(ll) and the phonon vibration frequency Eq.(12), we see that they are almost the same, 0.3 0.4 x 1014 s 1. This affirms the possibility of a spin-paired covalent-bonded electronic charge transfer. For vibrations in a linear crystal there are certainly low frequency acoustic vibrations in addition to the high frequency anti-symmetric vibrations which correspond to optical modes. Thus, there are other possibilities for refinement. In spite of the crudeness of the model, this sample calculation also gives a reasonable transition temperature, TR-B of 145 °K, as well as a reasonable cooperative electronic resonance and phonon vibration effect, to v. Consequently, it is shown that the possible existence of a COVALON conduction as suggested here is reasonable and lays a foundation for completing the story of superconductivity as described in the following. [Pg.77]

In case of non-primitive lattices with different atoms in the elementary cell, the sub-lattices can vibrate against each other (optical modes, see Figure 1.10). A vibration with a frequency iv 0 becomes possible even for k = 0. The opposite movement of neighboring atoms evokes large dipole moments allowing a coupling to electromagnetic waves. [Pg.22]

Lattice vibrations may be acoustic or optical in the former case the motion involves all the ions, in volumes down to that of a unit cell, moving in unison, while in the optical mode cations and anions move in opposite senses. Both acoustic and optical modes can occur as transverse or longitudinal waves. [Pg.60]

From the lattice dynamics viewpoint a transition to the ferroelectric state is seen as a limiting case of a transverse optical mode, the frequency of which is temperature dependent. If, as the temperature falls, the force constant controlling a transverse optical mode decreases, a temperature may be reached when the frequency of the mode approaches zero. The transition to the ferroelectric state occurs at the temperature at which the frequency is zero. Such a vibrational mode is referred to as a soft mode . [Pg.60]

Figure 2.38 illustrates that in the case of an ionic solid the optical mode of the lattice vibration resonates at an angular frequency, co0, in the region of 1013Hz. In the frequency range from approximately 109-10nHz dielectric dispersion theory shows the contribution to permittivity from the ionic displacement to be nearly constant and the losses to rise with frequency according to... [Pg.303]

The optical spectral region consists of internal vibrations (discussed in Section 1.13) and lattice vibrations (external). The fundamental modes of vibration that show infrared and/or Raman activities are located in the center Brillouin zone where k = 0, and for a diatomic linear lattice, are the longwave limit. The lattice (external) modes are weak in energy and are found at lower frequencies (far infrared region). These modes are further classified as translations and rotations (or librations), and occur in ionic or molecular crystals. Acoustical and optical modes are often termed phonon modes because they involve wave motions in a crystal lattice chain (as demonstrated in Fig. l-38b) that are quantized in energy. [Pg.70]

Dispersion of vibrations (i.e. of phonons) is neglected. This approximation is well adapted to the intramolecular vibrations and, to a less degree, to the libration modes, particularly to optical modes. [Pg.44]

The calculation of vibration spectra in terms of force constants is similar to the calculation of energy bands in terms of interatomic matrix elements. Force constants based upon elasticity lead to optical modes, as well as acoustical modes, in reasonable accord with experiment, the principal error being in transverse acoustical modes. The depression of these frequencies can be understood in terms of long-range electronic forces, which were omitted in calculations tising the valence force field. The calculation of specific heat in terms of the vibration spectrum can be greatly simplified by making a natural Einstein approximation. [Pg.203]


See other pages where Optical modes, vibration is mentioned: [Pg.55]    [Pg.6]    [Pg.18]    [Pg.26]    [Pg.269]    [Pg.321]    [Pg.304]    [Pg.269]    [Pg.55]    [Pg.6]    [Pg.18]    [Pg.26]    [Pg.269]    [Pg.321]    [Pg.304]    [Pg.269]    [Pg.53]    [Pg.300]    [Pg.72]    [Pg.248]    [Pg.74]    [Pg.247]    [Pg.23]    [Pg.45]    [Pg.270]    [Pg.278]    [Pg.505]    [Pg.173]    [Pg.93]    [Pg.81]    [Pg.81]    [Pg.208]    [Pg.26]    [Pg.22]    [Pg.53]    [Pg.547]    [Pg.244]    [Pg.288]    [Pg.216]   
See also in sourсe #XX -- [ Pg.207 ]




SEARCH



Optic mode

Optical modes

Vibrational mode longitudinal optical

Vibrational mode transverse optical

Vibrational modes

© 2024 chempedia.info