Objects, location

If we have narrow-band sensors where each sensor responds to a single wavelength X, with i e r, g, b, then the intensity /, measured by the sensor is simply the product of a geometry factor G, the illuminant L,(x, y) at the corresponding object location (x, y) and the reflectance R at this location. 

Correct conclusion Pressac reproduced a photo of crematorium II showing square objects located on the roof of morgue 1 (the fourth object obviously lies behind the cellar).243 The same photograph also appears in Danuta Czech s book.244 It was taken in early February 1943, see Fig. 36, the decisive detail of which being magnified in Fig. 37. If these objects are really Zyklon B introduction holes, as Pressac believes, then one must assume that the objects are ... 

Fig. 38 Schematic drawing of a view onto morgue 1 of crematorium II. Longitudinally painted the concrete longitudinal beam with the 7 supporting pillars. Drawn in as intersecting lines base-lines, upon which the middle of the three objects located on the roof must have been located.245 Obviously, they were not evenly distributed along the roof. Grey rectangle actual location of the two openings in existence today. ...

Figure 3.19 Calculated image for a 3 (Jim diameter circular object at a wavelength of 3 xm and at three different locations within the spectrometer s potential viewing area, illustrating diffraction blurring and optical distortion. Left centered on instrument s optic axis middle object located 100 pm from optic axis right object located 283 pm from optic axis.

Ennaceur A, Neave N, Aggleton JP. Spontaneous object recognition and object location memory in rats the effects of lesions in the cingulate cortices, the medial prefrontal cortex, the cingulum bundle and the fornix. Exp Brain Res 1997 113 ... 

Consider one arbitrary voxel of the extended object located at the position r relative to some coordinate scheme. If the voxel is small relative to the dimensions of the measuring arrangement, solid angle factors can be assumed to be constant and the total scatter signal can be represented in the following form ... 

New, unknown objects, located outside the boundaries of the models in question, can then be identified as outliers. The axes of a model can be related to properties. 

A second way to insure that children have access to the necessary information about the referent space is to give them mapping tasks while they are in the referent space itself. Illustrative is work in which children are asked to look around a room to find objects, and then mark the objects locations on a map of that room (e.g., Liben Downs, 1993 Liben Yekel, 1996), or to go to a location marked on a map of the room in which the child is being interviewed (e.g., Bluestein Acredolo, 1979 Presson, 1982). 

A few empirical studies have directly contrasted children s abilities to use oblique versus vertical views. Data suggest that the former are more easily decoded, and may even support transfer to the latter. For example, Liben and Yekel (1996) found that preschool children were significantly more accurate in placing stickers on classroom maps to indicate objects locations when the map was drawn from an oblique perspective than when drawn in plan view, and found that later performance on a plan map was significantly better when children had used the perspective map first. Some recent data collected by Blades, Hetherington, Spencer and... 

The debris from a bomb blast site usually contains traces of the undetonated explosive. Therefore, the location of the explosive at the point of detonation must be located and the debris and closely surrounding soil should be removed, packaged, and labeled. The objects located near the explosion are good sources of explosive residue. Wood, insulation, rubber, or other soft materials which are readily penetrated often collect traces of the explosive. 

Centralized control of various entities with different objectives, locations, and cultures is almost out of the question now. Control systems to enable effective coordination among distributed entities have become critical to modem manufacturing systems. 

The focus of hostilities, for example, has shifted from battlefields to urban centres over the past century. Fighting that targets military objectives located in densely populated areas or takes place in urban settings where civilian homes and infrastructure are destroyed rarely complies with the IHL principles of distinction, proportionality and precaution. 

The early three-dimensional seismic exploration found out two geological abnormal objects, located... 

Acquisition of full information about an object located at A. 

An intolerable rise in body temperature, as well as localized damage to specific organs, can result from an exposure of sufficient intensity and time. In addition, flammable gases and vapors may ignite when they are inside metallic objects located in a microwave beam. Power intensities for microwaves are given in units of milliwatts per square centimeter (mW/cm ), and areas having a power intensity of over 10 mW/cm for a period of 0.1 hours or longer should be avoided. 

Figure 3.32 Smart shirt worn by tbe mannequin moving toward an object located on the left (first case) and in the front (second case).

---