Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

OATED FABRICS

Figure 3. Oat / iV/ge National Laboratory unsaturatedflow facility. The intact cores are contained in large polyvinyl chloride pipes, and a filter membrane was c ed to the sediments within a fabricated acrylic endcap at the lower boundary. Tension was maintained through the large white vacuum chambers, which also housed a fraction collector for samples of column effluent. Influent was delivered by a multi-channel pump at the upper boundary. Tensiometers, visible in the side of... Figure 3. Oat / iV/ge National Laboratory unsaturatedflow facility. The intact cores are contained in large polyvinyl chloride pipes, and a filter membrane was c ed to the sediments within a fabricated acrylic endcap at the lower boundary. Tension was maintained through the large white vacuum chambers, which also housed a fraction collector for samples of column effluent. Influent was delivered by a multi-channel pump at the upper boundary. Tensiometers, visible in the side of...
Polyurethane leather substitute and nylon-6 meltvinyl fabrics were treated with elastomeric polycarbonates, such as polytetramethylene glycol-bisphenol A-phosgene polymer, poly(ethylene adipate)-4,4 -dihydroxydiphenyl-methane-phosgene polymer, or ethylene bis(p-hydroxybenzoate)-polytetra-methylene glycol-phosgene polymer to give products with improved abrasion resistance and flexural strength [253]. [Pg.580]

Bragg wavelengths were recorded within 60 minutes at different temperatures and relative humidity levels. These results show that this fabricated polyimidehumidity sensor has a stable sensing property for a long-term relative humidity monitoring. [Pg.152]

Novel polymer-ceramic nanocomposite membranes were fabricated, characterized, and tested for their barrier performance. Atomic layer deposition (ALD) was used to deposit alumina films on primary, micron-sized (16 and 60 pm) high-density polyethylene (HOPE) particles at a rate of 0.5 nm/cyde at 77 °C. Well-dispersed polymer-ceramic nanocomposites were obtained by extruding aluminapolymer particle size. The diffusion coefficient of fabricated nanocomposite membranes can be reduced to half with the inclusion of 7.29vol.% alumina flakes. However, a corresponding increase in permeability was also observed due to the voids formed at or near the interface of the polymer and alumina flakes during the extrusion process, as evidenced by electron microscopy [1]. [Pg.186]


See other pages where OATED FABRICS is mentioned: [Pg.940]    [Pg.940]    [Pg.490]    [Pg.426]    [Pg.662]    [Pg.31]    [Pg.12]    [Pg.149]    [Pg.1216]    [Pg.177]    [Pg.380]    [Pg.779]   


SEARCH



OAT

OATINGS

Oates

© 2024 chempedia.info