Nitroanisoles

The nitration of anisole in 40% aq. nitric acid in the presence of some nitrous acid yielded 2,4-dinitrophenol as the main product. In more concentrated solutions of nitric acid 0- and />-nitroanisoles were the main products, less than o-1 % of the weta-isomer being formed. " The isomeric ratios for nitration imder a variety of conditions are given later ( 5.3.4). 

The reaction of N bromosuccimmide with the following com pounds has been reported in the chemical literature Each compound yields a single product in 95% yield Identify the product formed from each starting material (a) p-tert Butyltoluene (b) 4 Methyl 3 nitroanisole... 

Nitroanisole (4-methoxynitrobenzene) [100-17-4] M 153.1, m 54". Crystd from pet ether or hexane and dried in vacuo. 

This procedure was applied to numerous solvatoehromie seales [Z, xr. Et (30)], using 4-nitroanisole as the solute ineapable of H bonding. As in the development of the TT seale, the a scale is averaged over several processes. A (3 seale of HBA ability (basicity) was established in a similar manner. Table 8-17 lists some tt, a, and (3 values. ... 

Various materials, present by accident or design, can alter the course of reduction by arresting the reaction at an intermediate product or by causing the formation of coupled products (94,95). These deviations can range from only a small yield loss to the formation of a major product. The work of Kosak (56) on o-nitroanisole is instructive in this regard, where small amounts of... 

There seem to have been only two investigations on dediazoniations in a protic solvent, where the observed products indicate that, in addition to DN + AN solvolysis, an aryne is likely to be present as a metastable intermediate. Broxton and Bunnett (1979) have found that 3-nitroanisole is formed in the dediazoniation of 2-nitroben-zenediazonium ions in methanol in the presence of methoxide ions. This has to be interpreted as a product arising from 3-nitro-l,2-benzyne as an intermediate. The occurrence of the aryne mechanism in poly (hydrogen fluoride)-pyridine mixtures, as discovered by Olah and Welch (1975), is mentioned in Section 8.2. 

First of all, there are the two products of O-coupling addition of methoxide ion to the diazonium ion, the (Z)- and (jE)-diazo methyl ethers. As discussed in Section 6.2, they are formed in reversible reactions with half-lives of the order of a fraction of a second (Z) to a minute (E). The two diazo ethers are, however, decomposed rapidly to the final dediazoniation products. We show in Scheme 8-47 the products obtained by Broxton and McLeish (1983 b) in the dediazoniation of 4-chloro-3-nitrobenzenedi-azonium ion (8.64) with methoxide ion in CH3OH. The products are 4-chloro-3-nitro-anisole (8.65, 49 9o), 2-chloro-nitrobenzene (8.66, 449o), and 2-nitroanisole (8.67). 

The level of deuteration found in the third product, 2-nitroanisole (8.67), is also consistent with these two pathways of hydro-de-diazoniation, but preceded in this case by a methoxy-de-chlorination. 

The positive bromination of aromatics ethers was first studied by Bradfield et al.193 and by Branch and Jones194. The reaction of hypobromous acid in 75 % aqueous acetic acid with benzyl 4-nitrophenyl ether and 4-nitrophenetole at 20 °C was very rapid and approximately second-order193. The value of k2/[H+] remained constant in the [H+] range 0.005-0.090 M for the effect of added mineral acids on the bromination of 4-nitroanisole and 4-nitrophenetole (at 19.8 °C)194. The variation in reaction rate with the percentage of acetic acid in the medium was also studied and showed a large increase in the 0-10 % range with a levelling off at approximately 25 % acetic acid (Table 52) this was attributed... 

---