Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

1.4- MPB

The synthesis of TNU-9 in the presence of 1,4-MPB was found to be possible only from synthesis mixtures with a very narrow range of Si02/ AI2O3 and Na0H/Si02 ratios, which is also the case of the 1,5-MPP-mediated synthesis of mainly due to the flexible nature of the... [Pg.292]

Table 5.3 Representative products obtained using l,4-bis(N-methylpyrrolidinium)-butane (1,4-MPB) as an OSD A. Reprinted with permission from S.B. Hong, Catal. Surv. Asia, Synthesis of all-silica molecular sieves in fluoride media. Vol 12, 131. Copyright (2008) Springer... Table 5.3 Representative products obtained using l,4-bis(N-methylpyrrolidinium)-butane (1,4-MPB) as an OSD A. Reprinted with permission from S.B. Hong, Catal. Surv. Asia, Synthesis of all-silica molecular sieves in fluoride media. Vol 12, 131. Copyright (2008) Springer...
Table 5.3 Representative products obtained using l,4-bis(A-methyl-pyrrolidinium) butane (1,4-MPB) as an organic SDA. ... Table 5.3 Representative products obtained using l,4-bis(A-methyl-pyrrolidinium) butane (1,4-MPB) as an organic SDA. ...
Block 1.5 mL (per selection) streptavidin M-280 Dynabeads by adding 5 mL 4% MPBS, and rotate in a 15-mL tube on an end-over-end mixer for 5 min at room temperature... [Pg.487]

Pour off the supernatant, and add another 5 mL 4% MPBS. Rotate for 1 h at room temperature, and separate again with a magnetic particle concentrator... [Pg.487]

Repeat the selection procedure another three to four times (use a 1 -mL aliquot for selection, and store the remaining phage at 4°C). For the second and subsequent rounds of selection, mix 1 mL phage from the previous round of selection with 0.5 mL of 6% MPBS, 10 pL Tween-20, and biotinylated antigen to give a final concentration of 50 nM Use only 300 pL of blocked streptavidin-coated Dynabeads... [Pg.487]

The kinetic procedure used for calculation of C from N-data (Sect. 4.1.2.1) can be modified to yield relevant equations applied when MPB-data are available. Thus, if Rp and Rtl are time-independent, then equations ... [Pg.91]

Prepare liposomes incorporating 1% /V-(4-(p-maleidophcnyl)butyryl)-l,2-.vn-distearoylphosphatidylethanolamine (MPB-DSPE) as described above. This should be done not more than 1 d prior to use. [Pg.57]

The initial PIA purification method was developed by Mack et al. (3). These authors used a different, two-step chromatography protocol involving size-exclusion and ion exchange chromatography on Sephadex G-200, Q-Sepharose, and S-Sepharose. A similar purification method has been described recently to isolate a PIA-related polysaccharide polymer in E. coli (7). Briefly, E. coli cells were incubated in 50 raM Tris-HCL buffer (pH 8.0), 100 mg lysozyme, and 0.1 M EDTA at room temperature for 2 h. Phenol/chloroform extraction steps were performed to separate protein and debris contamination from the polysaccharide. Samples were concentrated by ultrafiltration devices (10,000 MW cut off) and fractionated on a fast protein liquid chromatography (FPLC) system with a Sephacryl S-2000 column (equilibration and elution buffer 0.1 MPBS, pH 7.4). [Pg.103]


See other pages where 1.4- MPB is mentioned: [Pg.291]    [Pg.292]    [Pg.292]    [Pg.294]    [Pg.295]    [Pg.203]    [Pg.219]    [Pg.291]    [Pg.292]    [Pg.292]    [Pg.294]    [Pg.295]    [Pg.203]    [Pg.219]    [Pg.485]    [Pg.486]    [Pg.113]    [Pg.915]    [Pg.2366]    [Pg.756]    [Pg.353]    [Pg.874]    [Pg.881]    [Pg.487]    [Pg.487]    [Pg.564]    [Pg.572]    [Pg.138]    [Pg.141]    [Pg.53]    [Pg.307]    [Pg.367]    [Pg.190]    [Pg.88]    [Pg.95]    [Pg.366]    [Pg.252]    [Pg.309]    [Pg.377]    [Pg.544]    [Pg.552]    [Pg.8]    [Pg.733]    [Pg.113]    [Pg.353]    [Pg.149]    [Pg.16]   


SEARCH



Ferroelectric/piezoelectric MPBs)

MPB equation

MPB-DPPE

© 2024 chempedia.info