Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Stack molds

Slider mold Stack mold Three plate mold H... [Pg.337]

The soft-mud process is used to make handmade btick. Mote water is added to the clay to make a thinner paste, typicaHy about 20 to 30% by weight of water. The resulting slurry is packed into molds that have a sand or water coating on them that acts as a release agent. The wet brick shapes ate removed from the molds when they have set up enough to handle and ate then stacked for drying and burning. [Pg.324]

Jiang and Zhu (2000) and Qiu and Zhu (2001) have reported the fabrication of multilayered devices composed of stacks of compression-molded disks of alternating compositions. One type of disk is either P(SA-EG) or P[SA-co-TMAgly)-Z>-EG] and the other is a pH-sensitive, protein-loaded blend of, for example, poly(methacrylic acid) and polyethoxazoline. The release of model proteins, myoglobin, bovine serum albumin, and FITC-dextran, and compounds such as brilliant blue have been studied and pulsatile release profiles have been demonstrated (Jiang and Zhu, 2000 Qiu and Zhu, 2001). [Pg.210]

Molded articles may be prepared from the prepregs by compression and transfer molding. In general, several sheets of the prepreg are cut and stacked in a mold. For example, a prepreg was cured by heating for 80 s at 150-180°C at 100-200 bar. The cured sample had the physical properties shown in Table 11.4. [Pg.324]

Add 30 pL TEMED to 10 mL of gel solution, pour this solution between the plates to fill the gap completely, and insert the comb in the top of the mold (there is no stacking gel with this system) Leave for 10 min for gel to polymerize... [Pg.106]


See other pages where Stack molds is mentioned: [Pg.148]    [Pg.265]    [Pg.313]    [Pg.376]    [Pg.560]    [Pg.445]    [Pg.445]    [Pg.529]    [Pg.11]    [Pg.67]    [Pg.75]    [Pg.96]    [Pg.148]    [Pg.265]    [Pg.313]    [Pg.376]    [Pg.560]    [Pg.445]    [Pg.445]    [Pg.529]    [Pg.11]    [Pg.67]    [Pg.75]    [Pg.96]    [Pg.206]    [Pg.151]    [Pg.454]    [Pg.310]    [Pg.269]    [Pg.307]    [Pg.578]    [Pg.578]    [Pg.8]    [Pg.142]    [Pg.249]    [Pg.27]    [Pg.145]    [Pg.67]    [Pg.98]    [Pg.322]    [Pg.328]    [Pg.46]    [Pg.596]    [Pg.531]    [Pg.145]    [Pg.228]    [Pg.361]    [Pg.20]    [Pg.227]    [Pg.310]    [Pg.885]    [Pg.249]    [Pg.36]    [Pg.26]   
See also in sourсe #XX -- [ Pg.445 ]

See also in sourсe #XX -- [ Pg.445 ]




SEARCH



Mold types Stacked

Molds stack mold

Molds stack mold

Stacked mold

Stacked mold

© 2024 chempedia.info