Mixing Sigma mixer

Screw-Discharge Batch Mixers A variant of the sigma-blade mixer is now available with an extrusion-discharge screw located in the saddle section. During the mixing cycle the screw moves the material within the reach of the mixing olades, thereby accelerating the... 

Since paste mixing is not within the scope of this section, such widely used paste mixers as the sigma blade and banbury types will not be covered here but instead are discussed in Sec. IS. 

Kneaders, Z- and sigma-blade, and Banbury mixers as shown in Figure 7.20, are generally used for the mixing of high-viscosity liquids, pastes, rubbers, doughs, and so on. The tanks are usually mounted horizontally and two impellers are often used. The impellers... 

Hah, K. R. and Godfrey, J. C. Trans. Inst. Chem. Eng. 46 (1968) 205. The mixing rales of highly viscous Newtonian and non-Newtonian fluids in a laboratory sigma blade mixer. 

Mixing of the crystalline ingredients of oxidant, fuel elastomer binder (butadiene-2-methyl-5 vinyl-pyridine copolymer plasticized with the formal of diethylene glycol monobutyl ether) 26% by vol is done in a sigma blade mixer. The completed mix is blocked in a hydraulic press to form a chge suitable for extrusion. The extruded strand is cut into grain blanks which are cured at... 

The expts were conducted in stainless steel sigma-blade type mixers with proplnt mixing capacities of 60, 600 and 2000 lbs, respectively. Radioactivity measurements on samples taken from various locations in the batch at different mixing times were performed with a sodium iodide scintillation detector system... 

Fillers may be added to low-viscosity resins by conventional sigma-blade mixer or the same type of equipment used for mixing paint systems. Three roll mills are generally employed for more viscous systems to obtain thorough wetting of the filler by the resin matrix. 

---