Migration Test, accelerated

The US and EU accelerated migration test conditions for long term ambient storage, 10 d at 49 °C and 10 d at 40 °C, yield equivalent migration values to those calculated in Example 14-3 for ambient storage at 23 °C for six months ... 

This economical test exposes die climatically unstable points of electronic components. Due to the nature of the test, the entire board is evaluated. This test accelerates the mechanisms of electrochemical migration. Consequently, faults that previously would appear after months or even years can be detected during the development process. To identify potential weak points, the assembly is operated in standby mode and immersed in deionized water. Testing while the assembly is in full operation is even more effective. The sensitivity of the circuit to moisture exposure is assessed on the basis of flie recorded test current, combined with a subsequent examination of the assembly. Through weak point analysis, a Yes/No decision can be determined concerning the expected service life, of the assembly. 

So far, various studies focused on developing catalyst materials with improved ORR activity, but only few reported the stability and durability of ORR catalysts. The study of accelerated durability tests (ADT) in conjunction with electron microprobe analysis (BMPA), LEED, and XRD techniques on Pt-based al-loys ° observed hd metal dissolution, diffusion of 3bulk oxides on the surface, and migration and agglomeration of Pt. Yu et al. compared the durability and activity of PtCo/C with Pt/C catalysts. Throngh determination of the electrochemically active sniiace area, mass, and specific activities with respeet to the potential cycles, they found the overall cell performance of PtCo/C is higher than that of Pt/C. They also concluded that the observed dissolution of Co has no severe impact on the cell performanee or membrane conductance. Additionally, Popov et al studied the stabihty of Pt M/C for X = 1,3 and M = V, Fe, Ni, Co. ADT analyses revealed that Pt/C has the lowest activity when eompared to Pt-alloy catalysts, and that the metal dissolntion is lower for a Pt M ratio of 3 1 than compared to a 1 1 ratio. Also, Pt-Ni showed a lower dissolution rate than the other considered Pt-M alloys. 

If we compare the finite states of granite tested samples with deep seismic sounding of the Earth crust, the striking correspondence of seismic boundaries and the rupture state transitions under high PT - parameters become evident. The active tectonics, that is, shear stress action, provides the appearance of permeable faults, filled with debris of rocks that are cataclastically destroyed. The faults accelerate water (vapor) migration and this is... 

The next step is to test one or more of the selected concrete compositions using a compliance test that determines the chloride-penetration resistance. DuraCrete has adopted the rapid chloride migration (RCM) test for this purpose [21,25], which is a short-term test based on acceleration of chloride penetration by an electric field. 

---