Metalloporphyrins amperometric sensors

Although not strictly relevant to amperometric sensor technology, various metalloporphyrins [Co(III), Mn(III), Fe(III) Fig. 45] have been shown to sense anions potentiometrically with selectivity sequences dependent on the centrally bound metal (Amman et al., 1986 De et al., 1994). For example the anti-Hofmeister selectivity sequence SCN" > I" > CIO4 > N02 > Br > Cl- > NOJ was exhibited by PVC membrane electrodes containing [87]. 

Porphyrins are often employed in sensors on account of their ability to act as cation hosts and, with a suitable metal ion coordinated, as redox catalysts. Electropolymerised poly(metalloporphyrin)s have been used as potentiometric anion-selective electrodes [131] and as amperometric electrocatalytic sensors for many species including phenols [132], nitrous oxide [133] and oxygen [134]. Panasyuk et al. [135] have electropolymerised [nickel-(protoporphyrin IX)dimethylester] (Fig. 18.10) on glassy carbon in the presence of nitrobenzene in an attempt to prepare a nitrobenzene-selective amperometric sensor. Following extraction of the nitrobenzene the electrode was exposed to different species and cyclic voltammetric measurements made. A response was observed at the reduction potential of nitrobenzene (the polyporphyrin film acts only to accumulate the analyte and not in a catalytic fashion). Selectivity for nitrobenzene compared with w-nitroaniline and o-nitroto-luene was enhanced compared with an untreated electrode, while a glassy carbon-... 

Currently available amperometric and voltammetric porphyrinic sensors for detection of electroactive analytes are based on their electrochemical oxidation or reduction on polymeric conductive films of metalloporphyrins. If the current generated during the process is linearly proportional to the concentration of an andyte, the current can be used as an analytic signal. This current can be measured in either the... 

Electrochemical methods for NO determination offer several features that are not available with spectroscopic approaches. Perhaps the most important is the capability of microelectrodes to directly measure NO in single cells in situ, in close proximity to the source of NO generation. Figure 2 shows sensors that have been developed for the electrochemical measurement of NO. One is based on the electrochemical oxidation of NO on a platinum electrode (the classical Clark probe for detection of oxygen) and operates in the amperometric mode [17]. The other is based on the electrochemical oxidation of NO on conductive polymeric porphyrin (porphyrinic sensor) [24]. The Clark probe uses a platinum wire as a working electrode (anode) and a silver wire serves as the counterelectrode (cathode). The electrodes are mounted in a capillary tube filled with a sodium chlo-ride/hydrochloric acid solution separated from the analyte by a gas-permeable membrane. A constant potential of 0.9 V is applied, and direct current (analytical signal) is measured from the electrochemical oxidation of NO on the platinum anode. In the porphyrinic sensor, NO is catalytically oxidized on a polymeric metalloporphyrin... 

---