Metallates with carboxamides

Concerning the synthesis of 3-stannylbenzo[l,4]dioxin-2-carboxamides 62, when compounds 63 were treated with LDA (2 equiv) at —78°C, the corresponding metallated heterocycles was reacted with the trimethyltin or tributyltin chloride providing vinylstannanes 62 in high yields (Equation 7) <1997TL5635>. In the naphtho[2,3- ][l,4]dioxin series, the 2-diethylamido derivative can be metallated with LDA at —78°C and quenched with aldehydes <2002T1533>. 

The synthon of the a-acrylate anion is available from a secondary a-keto carboxamide by the Shapiro reaction. The secondary a-ketoamide trisylhydrazones ate ptepar in a one-pot synthesis by reaction of the isocyanides with acid chloride, water and trisylhydrazine in sequence. In DME solvent, the hydra-zone (103) is smoothly metallated with BuLi to give Ae trianion (KH). Allylation of the trianion (104) gives the hydrazone (105). Alternatively, warming (104) up to room temperature yields the dianion (106) which can be intercepted with several electrophiles (Scheme 23). The adduct (107) is readily transformed into the rran -iodo lactone (108) stereospecifically (equation 56). This chemistry also has been applied to a new synthesis of -lactams (Scheme 24). ... 

Secondary amines, such as pyrrolidine, must be alkylated with care too polar a solvent leads to participation of a second nearby polymer-bound alkylant in the formation of a quaternary ammonium salt, along with the desired immobilized trialkyl amine. The exception, as seen above, is diisopropylamine, which refuses to displace tosylate even in the refluxing pure amine, or in hot dimethyl-formamide or other polar solvent, while metal diisopropylamide is notorious as a powerful non-nucleophilic base. However, carboxamide is not difficult to form from (carboxymethyl)polystyrene, again using toluenesulfonyl chloride as condensing agent this can then be reduced to (diisopropyl-ethylaminoethyl)polystyrene, which is of interest as a polymer-bound non-nucleophilic base. ... 

Activation of a C-H bond requires a metallocarbenoid of suitable reactivity and electrophilicity.105-115 Most of the early literature on metal-catalyzed carbenoid reactions used copper complexes as the catalysts.46,116 Several chiral complexes with Ce-symmetric ligands have been explored for selective C-H insertion in the last decade.117-127 However, only a few isolated cases have been reported of impressive asymmetric induction in copper-catalyzed C-H insertion reactions.118,124 The scope of carbenoid-induced C-H insertion expanded greatly with the introduction of dirhodium complexes as catalysts. Building on initial findings from achiral catalysts, four types of chiral rhodium(n) complexes have been developed for enantioselective catalysis in C-H activation reactions. They are rhodium(n) carboxylates, rhodium(n) carboxamidates, rhodium(n) phosphates, and < // < -metallated arylphosphine rhodium(n) complexes. 

Chiral dirhodium(II) catalysts with carboxylate or carboxamidate ligands have recently been developed to take advantage of their versatility in metal carbene transformation, and these have now become the catalysts of choice for cyclopropanation. Chiral carboxylate ligands 195,103 196,104 and 197105 have been used for tetrasubstitution around a dirhodium(II) core. However, the enantioselectivity in intermolecular reactions with simple ketenes is marginal. 

Hydration of nitriles providing carboxamides is usually carried out m strongly basic or acidic aqueous media - these reactions require rather bars conditions and suffer from incomplete selectivity to the desired amide product. A few papers in the literature deal with the possibihty of transition metal catalysis of this reaction [28-30]. According to a recent report [30], acetonitrile can be hydrated into acetamide with water-soluble rhodium(I) complexes (such as the one obtained from [ RhCl(COD) 2] and TPPTS) under reasonably mild conditions with unprecedently high rate... 

With respect to the large number of unsaturated diazo and diazocarbonyl compounds that have recently been used for intramolecular transition metal catalyzed cyclopropanation reactions (6-8), it is remarkable that 1,3-dipolar cycloadditions with retention of the azo moiety have only been occasionally observed. This finding is probably due to the fact that these [3+2]-cycloaddition reactions require thermal activation while the catalytic reactions are carried out at ambient temperature. A7-AUyl carboxamides appear to be rather amenable to intramolecular cycloaddition. Compounds 254—256 (Scheme 8.61) cyclize intra-molecularly even at room temperature. The faster reaction of 254c (310) and diethoxyphosphoryl-substituted diazoamides 255 (311) as compared with diazoacetamides 254a (312) (xy2 25 h at 22 °C) and 254b (310), points to a LUMO (dipole) — HOMO(dipolarophile) controlled process. The A -pyrazolines expected... 

Early publications on [VO(/3-diketonato)2] have been reviewed.355 More recently, complexes with benzoyl m-nitroacetanilide, benzoyl acetanilide545 and l,l -(l,3-phenylene)-bis(butane-1,3-dione546 have been synthesized. Other [VO(/S-dik)2] adducts have been isolated, for example [VO(acac)2] adducts with a series of pyridine N-oxides547 and several pyridine carboxamides, 48 and [VO(bzac)2] adducts with pyridine, methylamine, isoquinoline and 4-picoline.549 Equilibrium constants of 1 1 and 2 1 adducts of pyrazine with [VO(tfacac)2] have been determined (equation 38).550 In the 2 1 complex, the pyrazine bridge between two equatorial sites of adjacent vanadium atoms promotes a weak exchange interaction. The nitroxide radical 2,2,6,6-tetramethylpiperidinyl N-oxide also forms an adduct with [VO(hfacac)2] in which there is a strong interaction between the electrons on the metal and nitroxide.551... 

---