Mechanical aeration characterization

Although each form of concentration cell may be considered a discrete form of corrosion, in practice, more than one type may occur simultaneously. These forms of corrosion are all characterized by localized differences in concentration of hydrogen, oxygen, chloride, sulfate, and other minerals, but especially oxygen (producing the so-called differential oxygen concentration cell, or differential-aeration cell). The basic mechanisms surrounding each of these specific forms of concentration cell corrosion are discussed next. 

Hi. Lysine. Gamma radiolysis of aerated aqueous solution of lysine (94) has been shown, as inferred from iodometric measurements, to give rise to hydroperoxides in a similar yield to that observed for valine and leucine. However, attempts to isolate by HPLC the peroxidic derivatives using the post-column derivatization chemiluminescence detection approach were unsuccessful. This was assumed to be due to the instability of the lysine hydroperoxides under the conditions of HPLC analysis. Indirect evidence for the OH-mediated formation of hydroperoxides was provided by the isolation of four hydroxylated derivatives of lysine as 9-fluoromethyl chloroformate (FMOC) derivatives . Interestingly, NaBILj reduction of the irradiated lysine solutions before FMOC derivatization is accompanied by a notable increase in the yields of hydroxylysine isomers. Among the latter oxidized compounds, 3-hydroxy lysine was characterized by extensive H NMR and ESI-MS measurements whereas one diastereomer of 4-hydroxylysine and the two isomeric forms of 5-hydroxylysine were identified by comparison of their HPLC features as FMOC derivatives with those of authentic samples prepared by chemical synthesis. A reasonable mechanism for the formation of the four different hydroxylysines and, therefore, of related hydroperoxides 98-100, involves initial OH-mediated hydrogen abstraction followed by O2 addition to the carbon-centered radicals 95-97 thus formed and subsequent reduction of the resulting peroxyl radicals (equation 55). 

Mechanical Cells. Figure 19-73 presents a schematic representation of a typical mechanical device commonly known as a flotation cell. It is characterized by a cubic or cylindrical shape, equipped with an impeller surrounded by baffles with provisions for introduction of the feed slurry and removal of froth overflow and tailings underflow. The machines receive the supply of air through a concentric pipe surrounding the impeller shaft, either by self-aeration due to the pressure drop created by the rotating impeller or by air injection by means of an external blower. In a typical installation, a number of flotation cells are connected in series such that each cell outputs froth into a launder and the underflow from one cell goes to the next one. The cell design may be such that the flow of slurry from one cell to another can either be restricted by weirs or unrestricted. 

---