Matching line

Neither frequency job produces any imaginary frequencies, indicating that both structures are minima. A quick way to check for this is to search the output file for the string imagin such a search indicates that there is no matching line in the file. 

Figure 6. Sketch of WMM-geometiy, matching line indicated by bullets.

Figure 7.15. A Self-Diagonal Plot For the TATA-Box-Binding Protein From the YXant Arabidopsis. Self-diagonal plots are used to search for amino acid sequence repeats within a protein. The central diagonal is the sequence aligned with itself Red dots indicating a correspondence of amino acids appear where two or more amino acids in a row match. Lines of dots, highlighted in pink, parallel to the central diagonal suggest an internal repeat.

The elements, the number of procedures which were developed, the detection limits, the concentration range at which the precision was measured, and the coefficient of variation are listed in Table l.L Figure 1.1 summarizes accuracy data for all of the methods that were developed, with 20% limits drawn around the theoretical match line. All of the data obtained at the initiating laboratories were within the 20% limit... 

The variation in response for the same amount of beryllium in different crudes prohibits the use of calibration curve techniques. Consequently, the method of standard additions was adopted to circumvent the variation in response. The applicability of the standard addition technique was evaluated by analyzing several types of petroleum samples that had been spiked with known amounts of beryllium using the Conostan beryllium standard. The results are shown in Figure 6.2. If the analyses were 100% accurate, all data points would fall on the diagonal match line. All experimental values agree with the known spike level within the precision of the method, suggesting that the standard addition technique compensates for the variation in response. 

Figure 1. Col linear configuration space, subdivided into regions (1-IV) in which different coordinate systems are used. Regions I and II are for reactants, and III and IV are for products. M is a matching line between reactants and products, and TC is tlie origin of the polar natural collision coordinates used in Regions II and III.

R , r, Y ) are coordinates of a three-dimensional space in which y is the polar coordinate. Fixing y reduces the three-dimensional space to a plane. In the same way (R, r, Y ) are coordinates of a three-dimensional space in which Y is the polar coordinate. Fixing Y reduces the three-dimensional v-space to a plane (usually the Y and Y planes are different). The intersection of two planes is a straight line termed here the matching line. In Ref. (8) it is proved that the equation of this line is determined from the relation... 

Fig. 12. The imaging location and the Bragg-matched wavelength AsMcy at each rotation angle S cy- The reconstructed image field is limited by the probe spectral band AAp. The dotted part of the Bragg-matched line corresponds to the portion of the image that will not be reconstructed by the probe beam. The peristrophic rotation angle

Fig. 17. The concept of the selective detection method. The dotted part of the Bragg-matched line corresponds to the portion of the image that will not be detected by the imager.

In a further example, an electrician in a roof space must match lines of wiring to a mental model of the house electrical circuit. 

Both thin- and thick-film technology allow planar microstrip or coplanar transmission lines. However, requirements on line and coupling-gap accuracy do not always permit traditional screen printing. Etching techniques or photosensitive paste systems offer a potential solution. LTCC provides more design freedom. Impedance-matched line transitions (e.g., from microstrip to stripline or to an embedded waveguide) are possible. 

---