Mallet

Hughes, T. J.R., Mallet, M. and Mizukami, A., 1986. A new finite element formulation for computational fluid dynamics II. Beyond SUPG. Cornput. Methods Appl Meek Eng. 54, 341-355. 

Don t install bearings with mallets, or hammers and wood blocks. 

B. L. Henke, J. B. Newkirk, and G. R. Mallet, Eds. Advances in X-Ray Analysis. Plenum, New York, 1970, Vol. 13. The proceedings of the 18th Annual Denver Conference on Applications of X-ray Analysis the central theme of the Conference was interactions and applications of low-energy X-rays. 

T8373 F. Trecourt, M. Mallet, O. Mongin, B. Gervais, and G. Queguiner,... 

Maisan, M P, W Wainock, L Mallet, Y Nakatani,G Ootisson, andA Milon. I Ong Chstn., 61, 4252 H996 ... 

Schlegel, m. mallet, beater, beetle, (wooden) hammer drumstick. 

A mallet is composed of a section of a right circular cylinder welded to a cylindrical shaft, as shown in Figure 2-4a and b. Both components are steel, and the density is uniform throughout. Find the centroid of the mallet. 

Install a dial indicator with the stem against the shoulder of the shaft. Use a soft hammer or mallet to lightly tap the shaft on one end and then on the other. Total indicated end play should be between 0.001 and 0.004 inches. A mechanical seal cannot work properly with a large amount of end play or lateral movement. If the hydraulic condition changes (as frequently happens), the shaft could float, resulting in sealing problems. Minimum end play is a desirable condition for the following reasons ... 

Never use wooden mallets, brittle or chipped tools, or dirty fixtures and tools when bearings are being installed. 

---