Lathe machining

Figure 4.2.6 shows the sequential photographs of the propagating flame in a tube mounted on a lathe machine and rotated at 1210 rpm. One end was closed and the other end was open, where the mixture was ignited. Although a flame projected into the tube first, the flame... 

A collapsible mandrel is prepared by applying a very thin coat of silicone grease on it followed by application of aluminum foil of suitable thickness. This prepared mandrel is then held in the lathe machine. A thin uniform coat of resin (novolac epoxy resin plus hardener) is applied to the prepared collapsible mandrel revolving at a speed of 40 rpm and is allowed to cure partially. Then the dried rayon thread on a spool is passed through the resin formulation and is wound on to the mandrel... 

This report discusses four technologies single water jet, spinning twin water jets, lathe machining, and rotary knife grinding (RKG). The size reduction methods are compared among each other for safety, efficiency, and performance. 

The magnitude of these variations is dependent on the quality of the lathe machine. However, once the tool is sufficiently worn, there will be significant change in the dimensions and variation will no longer be confined within control zone. In that case, one can identify the cause and replace the tool. Shewhart is called as the father of statistical quality control by many. 

A regular metal removal process, lathe machining, has been shown to be a possible method for producing a wide group of nanocrystalline metals and alloys at very low... 

Machine tool Conventional centre lathe (Machine shop at BVBCET, Hubli)... 

Articulate patellar was made by compacting bulk polyethylene powder into the die. The material that used to produce articulate patellar is all-polyethylene. In this study, only the dome shape will be manufactured by using CNC lathe machine (Miyano) in the Department of Engineering Design machining laboratory. 

---