Large-signal amplifiers

Otherwise called power amphfiers, large-signal amplifiers are used at the end of systems that require high switching currents to drive a motor. The efficiency of a power amplifier is measured from the ratio of power OUT to power IN. 

At steady state CC=0, so this system can not control the steady state. Alternatively, it can give a large signal, if the wanted value (Cl) suddenly changes. In this way the system can to some degree overcome the sloppiness created by the integral system or other slow changes in the system. A minus is that this kind of control can create instabilities and amplify noise, so it can not stand alone. 

Here we describe an improved version of the electrically amplified medium in which the optical recording occurs in a polymer layer on top of the photoconductor sandwich. The marks formed in the polymer are highly symmetric bumps that should exhibit a large signal-to-noise ratio. 

RF Amplifier It is one of the major building blocks of modern RF circuits. The amplifier is usually required to provide low noise gain with low distortion at both small and large signal levels. It should also be stable, i.e. not generate unwanted spurious signals, and the performance should remain constant with time. The input and output match is also desirable. Thus for amplifier we require ... 

Because of the assumptions made about the saturated Class C amplifier before its mathematical analysis, it must be realized that the final circuit will need adjusting to get it to work right. Large signal... 

We have simulated the movement of carriers in the channel in response to the application of a step voltage in MATLAB , the results of which are presented in Fig. 4. There is a finite amount of time when the drain current is identically equal to zero, and the time delay is inversely proportional to the mobility of the transistor. The inverse of the delay time gives the characteristic frequency of the transistor operating as an amplifier. Determination of this parameter, therefore, specifies both the small-signal frequency and large-signal transient response of the device. 

---