Isoelectric point, silica surface

The effect of pH on the protein adsorption on CMK-3 was also investigated [152], The monolayer adsorption capacities obtained under various pH conditions are plotted in Figure 4.12, where the maximum adsorption was observed in the pH region near the isoelectric point of lysozyme (pi of about 11). Near the isoelectric point, the net charges of the lysozyme molecule are minimized and would form the most compact assembly. A similar pH effect was also seen in the adsorption of cytochrome c on CM K-3. Although the nature of the surface of mesoporous silica and... 

To evaluate the interaction between protein and the mesoporous silica surface, the immobilisation of GFP was performed also on Aerosil amorphous silica nanoparticles. The isoelectric point (pi) of GFP is 5.78. At pH 7.4, above pi, protein is negatively charged whilst the silica surface is positively charged [5,6], Hence, the higher the protein negative charge, the stronger the electrostatic interaction between GFP and silica surface. 

The surface of uncalcined aluminas consists of amphoteric hydroxyl groups that are even less acidic than those in silica gel. Electrophoretic measurements by Stigter et al. (90) show that the isoelectric point for alumina is attained at a pH of 9, much higher-than the value of 2 obtained in the case of silica gel. Thus, hydroxylated aluminas are relatively non-acidic, unless they are promoted with acid-producing impurities. 

The adsorption of ionic or polar surfactants on charged or polar surfaces involves coulombic (ion-surface charge interaction), ion-dipole, and/or dipole-dipole interaction. For example, a negatively charged silica surface (at a pH above the isoelectric point of the surface, i.e., pH >2-3)... 

Adsorption of ETES and VTES on Alumina. In the absence of acid or base catalysts it was not possible to obtain ETES films on a-alumina by retraction and the VTES films were unstable toward the organic test liquids as well as water. This failure of both the ETES and VTES to form strongly held films can be attributed to the weakly basic character of alumina surfaces. The isoelectric point of alumina is usually at a pH of 7.5 to 9.0 (11) which is a rough measure of the base strength of the —A1—OH surface groups. Silica, on the other hand, has an isoelectric point at a pH of 2, signifying a moderately strong acid character for the... 

Interactions between the ceria abrasives and the oxide surface have been investigated using both the chemical and the instrumental approaches. Suphantharida and Osseo-Asare [27] used zeta-potential measurements, silicate adsorption, and polishing experiment to investigate the role of ceria abrasives-Si02 surface interaction. T o determine the effect of pH on the surface charges, the zeta potentials of abrasive particles were measured (Fig. 13.21). The points of zero charge (pzc) or isoelectric point is at pH 6.0 for ceria and pH 1.5 for silica. These values are consistent with those reported by others [28,29]. 

---