Activity coefficient ionic

Table 8.4 Individual Ionic Activity Coefficients at Higher Ionic Strengths at...

Although it is not possible to measure an individual ionic activity coefficient,, it may be estimated from the following equation of the Debye-Hiickel theory ... 

At moderate ionic strengths a considerable improvement is effected by subtracting a term bl from the Debye-Hiickel expression b is an adjustable parameter which is 0.2 for water at 25°C. Table 8.4 gives the values of the ionic activity coefficients (for Zi from 1 to 6) with d taken to be 4.6A. 

In general, the mean ionic activity coefficient is given by... 

The activity of any ion, a = 7m, where y is the activity coefficient and m is the molaHty (mol solute/kg solvent). Because it is not possible to measure individual ionic activities, a mean ionic activity coefficient, 7, is used to define the activities of all ions in a solution. The convention used in most of the Hterature to report the mean ionic activity coefficients for sulfuric acid is based on the assumption that the acid dissociates completely into hydrogen and sulfate ions. This assumption leads to the foUowing formula for the activity of sulfuric acid. 

Y- Mean ionic activity coefficient of solute Dimensionless Dimensionless... 

If a buffer solution is diluted, the ionic concentrations are decreased and so, as shown in Section 2.5, the ionic activity coefficients are increased. It follows from equation (26) that the pH is increased. 

E6.12 The HC1 pressure in equilibrium with a 1.20 molal solution is 5.15 x 10 8 MPa and the mean ionic activity coefficient is known from emf measurements to be 0.842 at T = 298.15 K. Calculate the mean ionic activity coefficients of HC1 in the following solutions from the given HC1 pressures... 

Equations (7.35) and (7.36) can be used to calculate the activity coefficients of individual ions. However, as we discussed in Chapter 6, 7+ and 7- cannot be measured individually. Instead, 7 , the mean ionic activity coefficient for the electrolyte, M +AV-, given by... 

Figure 9.6 Mean ionic activity coefficients for HCl(aq) at T = 298.15 K obtained from the emf results of G. A. Linhart, J. Am. Chem. Soc.. 41, 1175-1180 (1919). The dashed line is the Debye-Huckel limiting law prediction.

Therefore the real and chemical ionic activity coefficients are related by the formula ... 

As a result of these electrostatic effects aqueous solutions of electrolytes behave in a way that is non-ideal. This non-ideality has been accounted for successfully in dilute solutions by application of the Debye-Huckel theory, which introduces the concept of ionic activity. The Debye-Huckel Umiting law states that the mean ionic activity coefficient y+ can be related to the charges on the ions, and z, by the equation... 

Ionic activity essentially represents the concentration of a particular type of ion in aqueous solution and is important in the accurate formulation of thermodynamic equations relating to aqueous solutions of electrolytes (Barrow, 1979). It replaces concentration because a given ion tends not to behave as a discrete entity but to gather a diffuse group of oppositely charged ions around it, a so-called ionic atmosphere. This means that the effective concentration of the original ion is less than its actual concentration, a fact which is reflected in the magnitude of the ionic activity coefficient. 

Here/+ is the mean ionic activity coefficient defined, by analogy with the mean ionic activity, as... 

For symmetric electrolytes i=l for 1 2 electrolytes (e.g., Na2S04), 1 3 electrolytes (AICI3), and 2 3 electrolytes ([Al2(S04)3], the corresponding valnes of A, are 1.587, 2.280, and 2.551. Mean ionic activity coefficients of many salts, acids, and bases in binary aqneons solutions are reported for wide concentration ranges in special handbooks. 

As a result, we obtain for the mean ionic activity coefficient,... 

By plotting the left-hand side of eqn. 2.65 against to and extrapolating back to to = 0 the intercept at to = 0 gave the value of J lgci/Ag = 0.2225 V at 25° C20 (cf., 0.2223 V21). Once E° is known, the measurement of E as a function of to provides an important method for determining molal ionic activity coefficients and a paH scale with the above type of cell, which permits a comparison with the Sorensen psH scale (cf., p. 33). 

All quantities in Eq. (12.6) are measurable The concentrations can be determined by titration, and the combination of chemical potentials in the exponent is the standard Gibbs energy of transfer of the salt, which is measurable, just like the mean ionic activity coefficients, because they refer to an uncharged species. In contrast, the difference in the inner potential is not measurable, and neither are the individual ionic chemical potentials and activity coefficients that appear on the right-hand side of Eq. (12.3). 

Figure 7.9 The dependence of the mean ionic activity coefficient y on concentration for a few simple solutes...

We need a slightly different form of y when working with electrolyte solutions we call it the mean ionic activity coefficient y , as below. 

The mean ionic activity coefficient is obtained as a geometric mean via... 

We assume that the activity coefficient of the ion-pairs is unity and denote the mean ionic activity coefficient by y . The thermodynamic equilibrium constant for the dissociation is then given by the equation... 

Once the composition of the aqueous solution phase has been determined, the activity of an electrolyte having the same chemical formula as the assumed precipitate can be calculated (11,12). This calculation may utilize either mean ionic activity coefficients and total concentrations of the ions in the electrolyte, or single-ion activity coefficients and free-species concentrations of the ions in the electrolyte (11). If the latter approach is used, the computed electrolyte activity is termed an ion-activity product (12). Regardless of which approach is adopted, the calculated electrolyte activity is compared to the solubility product constant of the assumed precipitate as a test for the existence of the solid phase. If the calculated ion-activity product is smaller than the candidate solubility product constant, the corresponding solid phase is concluded not to have formed in the time period of the solubility measurements. Ihis judgment must be tempered, of course, in light of the precision with which both electrolyte activities and solubility product constants can be determined (12). 

DIPA) and methyldiethanolamine (MDEA) have also been employed. Earlier, Atwood et al. (J 5) proposed a thermodynamic model for the equilibria in I S+alkanol-amine+H20 systems. The central feature of this model is the use of mean ionic activity coefficient. The activity coefficients of all ionic species are assumed to be equal and to be a function only of ionic strengths. Klyamer and Kolesnikova ( 1j[) utilized this model for correlation of equilibria in C02+alkanol-amine+H O systems and Klyamer et al. (J 7) extended it to the H2S+C02+alkanolamine+H20 system. The model is restricted to low pressures as the fugacity coefficients are assumed unity and it has been found that the predictions are inaccurate in the four-component system since the activity coefficients are not equal when a number of different cations and anions are present. 

---