Copolymers infrared spectroscopy

Alternation is usually above 90%. Nearly perfect alternation of isomeric units in a ca 1 1 monomer ratio has been confirmed by infrared spectroscopy. Bands at 733 and 721 cm have an intensity proportional to the concentration of (CH2) groups (n = 4 and <6, respectively) present in a copolymer containing 46 mol % tetrafluoroethylene intensity decreases with increasing concentration of fluorinated monomer. 

Tosi, C. and Ciampelli, F. Applications of Infrared Spectroscopy to Ethylene-Propylene Copolymers. Vol. 12, pp. 87-130. 

A combination of infrared spectroscopy with size exclusion chromatography has a wide application range in the characterization of copolymers, adhesives, impurity profiling in polymers and branching in polyolefines [60-65]. Commonly, the solvent used as a mobile phase absorbs strongly in the... 

Principal Component Regression (PCR) was used by Tuchbreiter and MueUiaupt to determine the composition of a number of random ethane/propene, ethane/1-hexene, and ethane/l-octene copolymers [120]. After polymerization, the polymers were characterized by both Attenuated Total Reflection Fourier Transform Infrared Spectroscopy (ATR-FT-IR) and C NMR and multivariate calibration models using PCR were subsequently developed to estimate the co-monomer content. 

Tuchbreiter A, Marquardt J, Zimmermann J et al. (2001) High-throughput evaluation of olefin copolymer composition by means of attenuated total reflection fourier transform infrared spectroscopy. J Comb Chem 3 598-603... 

The insoluble material is assumed to be the graft copolymer and this is verified by infrared spectroscopy. For grafting onto the butadiene portion of a copolymer, the C-H out-of-plane bending vibrations as well as the olefin C-H stretching vibration are most useful. The graft copolymer of acrylonitrile onto polystyrene cannot be analyzed by infrared spectroscopy since the only change would be in the C-H overtone region and these bands are too weak to permit interpretation. 

One may perform radical graft copolymerizations onto the butadiene region of copolymers of styrene and butadiene without any reaction occurring at the styrene portions of the copolymer. If the monomer is reactive, reaction of the monomer at an allylic site occurs while for less reactive monomers, the polymeric radical is formed and this adds to the double bond of the polymer. Proof of the site of grafting comes from information about the relative efficiency of different initiators but the most important information is obtained from infrared spectroscopy. One can observe differences in the spectra which can be related to the mode of addition. 

Infrared Spectroscopy. The following bands are seen in the ir spectrum of PPG 2970, 2940, 2880 cm-1 (C—H stretch, m) 1460,1375 cm-1 (C—H bend, m) 1100,1015 cm-1 (C—O stretch, m) of which the 2940 and 1015 band are specific. The latter are also present in copolymers of EO and PO. Absorptions due to unsaturated end groups are found at 1650 cm-1 (allyl ether) and 1672 cm-1 (1-propenyl ether). The O—H stretching band at 3470 cm-1 shows the greatest variation for different hydroxyl number polyols and has been used to estimate the hydroxyl number (169). 

Vasiliu, Feldman, and Simionescu (67) grafted acrylonitrile onto cotton and poplar fluff cellulose which were ozonized before the grafting reaction. The authors characterized the graft copolymer by nitrogen analysis and by infrared spectroscopy and studied their behaviour towards acids, bases and swelling agents. 

Deters, and Huang (129) describe the formation of graft copolymers of cellulose triacetate and vinyl chloride in vibratory mill treatments. Through hydrolytic degradation of the triacetate backbone, they isolated the polyvinyl chloride side chains and characterized them by infrared spectroscopy and cryoscopic molecular weight determination. The length of the side chains has been found to be between 15 and 30 vinyl chloride units. 

---