Impedance spectroscopy characterization procedure

The impedance spectroscopy is most promising for electrochemical in situ characterization. Many papers have been devoted to the AB5 type MH electrode impedance analysis [15-17]. Prepared pellets with different additives were used for electrochemical measurements and comparing. Experimental data are typically represented by one to three semicircles with a tail at low frequencies. These could be described to the complex structure of the MH electrode, both a chemical structure and porosity [18, 19] and it is also related to the contact between a binder and alloy particles [20]. The author thinks that it is independent from the used electrolyte, the mass of the electrode powder and the preparing procedure of electrode. However, in our case the data accuracy at high frequencies is lower in comparison with the medium frequency region. In the case, the dependence on investigated parameters is small. In Figures 3-5, the electrochemical impedance data are shown as a function of applied potential (1 = -0.35V, 2 = -0.50V and 3 = -0.75V). 

The avidin-biotin procedure has been extensively used in hybridization studies. Since the concentration of all analysed DNAs used is identical, the total concentration of the analysed samples is high. The amplification of the base-mismatch recognition event is necessary to improve sensitivity. The use of oligonucleotide-functionahzed Uposomes or biotin-labelled liposomes as probes for the dendritic amphfication of DNA-sensing processes was characterized by Willner and co-workers [62] and showed better performance using QCM than impedance spectroscopy measurements. 

---