Hydrogen, on Raney nickel

Addition of carbenes. Aryl acetylenes condense with the chlorinated oxocarbene 202 (35 hours at 100°) and give, through 1,3-cycloaddition, 3-substituted 4,5,6,7-tetrachloro-2-phenylbenzofurans (203).459 Compound 203 is readily dechlorinated (hydrogenation on Raney nickel in... 

Fig. 7,6 INS of hydrogen on Raney nickel. Integrated intensity 600-1200 cm vj dihydrogen pressure. Reproduced from [26] with permission from Elsevier.

Hydrogenation on Raney nickel at room temperature has proved to be very useful for splitting of the N—N bond in neutral bicycles of this type. Diazacyclooctanes (229) <58CB1982, 65CB3228,... 

Succinic acid can also be produced by catalytic hydrogenation of aqueous solutions of maleic or fumaric acid in the presence of noble metal catalysts, ie, palladium, rhodium, mthenium, or their mixtures, on different carriers (135—139) or on Raney nickel (140). 

This group is prepared by the reaction of the anion of 9-hydroxyanthracene and the tosylate of an alcohol. Since the formation of this group requires an S 2 displacement on the alcohol to be protected, it is best suited for primaiy alcohols. It is cleaved by a novel singlet oxygen reaction followed by reduction of the endo-peroxide with hydrogen and Raney nickel. 

The hydrogenation of pyrazolylacetylenes shows no peculiarities. Ethynylpyra-zoles are hydrogenated in high yields to the corresponding ethane derivatives on Raney nickel catalyst, platinum dioxide, or palladium catalyst at room temperature in alcohol solution. 

That the reaction with a lower rate constant is taking place preferentially and that the rate increases during the reaction are phenomena that can also occur with parallel reactions. As an example, Wauquier and Jungers (48), when studying competitive hydrogenation of a series of couples of aromatic hydrocarbons on Raney-nickel, have observed these phenomena for the couple tetraline-p-xylene (Table I). The experimental result was... 

If, for the purpose of comparison of substrate reactivities, we use the method of competitive reactions we are faced with the problem of whether the reactivities in a certain series of reactants (i.e. selectivities) should be characterized by the ratio of their rates measured separately [relations (12) and (13)], or whether they should be expressed by the rates measured during simultaneous transformation of two compounds which thus compete in adsorption for the free surface of the catalyst [relations (14) and (15)]. How these two definitions of reactivity may differ from one another will be shown later by the example of competitive hydrogenation of alkylphenols (Section IV.E, p. 42). This may also be demonstrated by the classical example of hydrogenation of aromatic hydrocarbons on Raney nickel (48). In this case, the constants obtained by separate measurements of reaction rates for individual compounds lead to the reactivity order which is different from the order found on the basis of factor S, determined by the method of competitive reactions (Table II). Other examples of the change of reactivity, which may even result in the selective reaction of a strongly adsorbed reactant in competitive reactions (49, 50) have already been discussed (see p. 12). 

The kinetics of hydrogenation of phenol has already been studied in the liquid phase on Raney nickel (18). Cyclohexanone was proved to be the reaction intermediate, and the kinetics of single reactions were determined, however, by a somewhat simplified method. The description of the kinetics of the hydrogenation of phenol in gaseous phase on a supported palladium catalyst (62) was obtained by simultaneously solving a set of rate equations for the complicated reaction schemes containing six to seven constants. The same catalyst was used for a kinetic study also in the liquid phase (62a). 

Epimerization of 50 at C-3 furnished carba-a-DL-allopyranose (60). Stepwise, 0-isopropylidenation of 50 with 2,2-dimethoxypropane afforded compound 56. Ruthenium tetraoxide oxidation of 56 gave the 3-oxo derivative 57, and catalytic hydrogenation over Raney nickel converted 57 into the 3-epimer 58 exclusively. Hydrolysis of 58, and acetylation, provided the pentaacetate 59, which was converted into 60 on hydrolysis. ... 

Supported Co, Ni, Ru, Rh, Pd and Pt as well as Raney Ni and Co catalysts were used for the hydrogenation of dodecanenitrile to amines in stirred SS autoclaves both in cyclohexane and without a solvent. The reaction temperature and the hydrogen pressure were varied between 90-140 °C and 10-80 bar, respectively. Over Ni catalysts NH3 and/or a base modifier suppressed the formation of secondary amine. High selectivity (93-98 %) to primary amine was obtained on Raney nickel, Ni/Al203 and Ru/A1203 catalysts at complete nitrile conversion. With respect to the effect of metal supported on alumina the selectivity of dodecylamine decreased in the order Co Ni Ru>Rh>Pd>Pt. The difference between Group VIII metals in selectivity can be explained by the electronic properties of d-band of metals. High selectivity to primary amine was achieved on base modified Raney Ni even in the absence of NH3. 

These are converted into chiral a-amino acids (5) on hydrogenation with Raney nickel. 

Furfural is obtained industrially (200000 t a-1) by dehydration of pentoses produced from hemicelluloses. Furfurylic alcohol is obtained by selective hydrogenation of the C=0 bond of furfural, avoiding the hydrogenation of the furan ring. Liquid phase hydrogenation at 80 °C in ethanol on Raney nickel modified by heteropolyacid salts resulted in a 98% yield of furfuryl alcohol [31]. 

More recently Hartog and Zwietering (103) used a bromometric technique to measure the small concentrations of olefins formed in the hydrogenation of aromatic hydrocarbons on several catalysts in the liquid phase. The maximum concentration of olefin is a function of both the catalyst and the substrate for example, at 25° o-xylene yields 0.04, 1.4, and 3.4 mole % of 1,2-dimethylcyclohexene on Raney nickel, 5% rhodium on carbon, and 5% ruthenium on carbon, respectively, and benzene yields 0.2 mole % of cyclohexene on ruthenium black. Although the cyclohexene derivatives could not be detected by this method in reactions catalyzed by platinum or palladium, a sensitive gas chromatographic technique permitted Siegel et al. (104) to observe 1,4-dimethyl-cyclohexene (0.002 mole %) from p-xylene and the same concentrations of 1,3- and 2,4-dimethylcyclohexene from wi-xylene in reductions catalyzed by reduced platinum oxide. 

Hydrogenation over Raney nickel was found to be even less stereoselective. 2-, 3- and 4-methylmethylenecyclohexenes gave different mixtures of cis and irons dimethylcyclohexanes depending not only on the structure of the starting alkene but also on the method of preparation and on the freshness of the catalysts. The composition of the stereoisomers ranged from 27-72% cis to 28-73% irons [340],... 

Hydrogenation using Raney nickel is carried out under mild conditions and gives cis alkenes from internal alkynes in yields ranging from 50 to 100% [356, 357, 358, 359, 360]. Half hydrogenation of alkynes was also achieved over nickel prepared by reduction of nickel acetate with sodium borohydride (P-2 nickel, nickel boride) [349,361,362] or by reduction with sodium hydride [49], or by reduction of nickel bromide with potassium-graphite [363]. Other catalysts are palladium on charcoal [364], on barium sulfate [365, 366], on... 

Aluminum amalgam in wet tetrahydrofuran reduced cumulene 1,1,4,4-tetraphenylbutatriene to 1,1,4,4-buta-1,2-diene, which on hydrogenation over Raney nickel was converted to 1,1,4,4-tetraphenylbutane [14S]. 

Triple bonds in side chains of aromatics can be reduced to double bonds or completely saturated. The outcome of such reductions depends on the structure of the acetylene and on the method of reduction. If the triple bond is not conjugated with the benzene ring it can be handled in the same way as in aliphatic acetylenes. In addition, electrochemical reduction in a solution of lithium chloride in methylamine has been used for partial reduction to alkenes trans isomers, where applicable) in 40-51% yields (with 2,5-dihydroaromatic alkenes as by-products) [379]. Aromatic acetylenes with triple bonds conjugated with benzene rings can be hydrogenated over Raney nickel to cis olefins [356], or to alkyl aromatics over rhenium sulfide catalyst [54]. Electroreduction in methylamine containing lithium chloride gives 80% yields of alkyl aromatics [379]. 

---