Hydrogen bonding very strong bonds

Bfi and 022- However, in the second binary, intermolecular forces between unlike molecules are much stronger than those between like molecules chloroform and ethyl acetate can strongly hydrogen bond with each other but only very weakly with them-... 

Color from Vibrations and Rotations. Vibrational excitation states occur in H2O molecules in water. The three fundamental frequencies occur in the infrared at more than 2500 nm, but combinations and overtones of these extend with very weak intensities just into the red end of the visible and cause the blue color of water and of ice when viewed in bulk (any green component present derives from algae, etc). This phenomenon is normally seen only in H2O, where the lightest atom H and very strong hydrogen bonding combine to move the fundamental vibrations closer to the visible than in any other material. 

The amount of polar monomer one would copolymerize with the alkyl acrylate monomer(s) very much depends on the type of polar monomer and the desired change in rheological properties one would like to achieve. Strong hydrogen bonding monomers, such as acrylic acid, methacrylic acid, acrylamide, or methacrylamide are typically used at levels of 12% or less of the total monomers. 

In media such as water and alcohols, fluoride ion is strongly solvated by hydrogen bonding and is neither very basic nor very nucleophilic. On the other hand, the poorly solvated, or naked, fluoride ions that aie present when potassium fluoride dissolves in benzene in the presence of a crown ether aie better able to express their anionic reactivity. Thus, alkyl halides react with potassium fluoride in benzene containing 18-crown-6, thereby providing a method for the preparation of otherwise difficultly accessible alkyl fluorides. 

Most nonpolar substances have very small water solubilities. Petroleum, a mixture of hydrocarbons, spreads out in a thin film on the surface of a body of water rather than dissolving. The mole fraction of pentane, CsH12, in a saturated water solution is only 0.0001. These low solubilities are readily understood in terms of the structure of liquid water, which you will recall (Chapter 9) is strongly hydrogen-bonded. Dissimilar intermolecular forces between C5H12 (dispersion) and H2O (H bonds) lead to low solubility. 

Ammonia is very soluble in water because the NH3 molecules can form hydrogen bonds to H20 molecules. Ammonia is a weak Bronsted base in water it is also a reasonably strong Lewis base, particularly toward d-block elements. For example, it reacts with Cu2+(aq) ions to give a deep-blue complex (Fig. 15.4) ... 

The effect of molecular interactions on the distribution coefficient of a solute has already been mentioned in Chapter 1. Molecular interactions are the direct effect of intermolecular forces between the solute and solvent molecules and the nature of these molecular forces will now be discussed in some detail. There are basically four types of molecular forces that can control the distribution coefficient of a solute between two phases. They are chemical forces, ionic forces, polar forces and dispersive forces. Hydrogen bonding is another type of molecular force that has been proposed, but for simplicity in this discussion, hydrogen bonding will be considered as the result of very strong polar forces. These four types of molecular forces that can occur between the solute and the two phases are those that the analyst must modify by choice of the phase system to achieve the necessary separation. Consequently, each type of molecular force enjoins some discussion. 

---