Helium leak detection detector-probe technique

Fig. 7.59 In the detector-probe technique, the tested piece is filled with helium and the sniffer probe sniffs the areas in question to detect leaks. Always sniff from bottom to top.

Aside from permeability and absorbency complications, other universal concerns of helium leak detection are factors such as source operating pressure, spraying patterns (for tracer-probe technique), response time, clean-up time, and cold trap usage. Pump use and general helium leak detector maintenance operations are also fairly universal. 

Most helium leak detectors will not operate with pressures above lO"4 torr to 10 5 torr. At these greater pressures, the main element to the mass spectrometer will bum out. Fortunately most, if not all, helium leak detectors have various safety check mechanisms that automatically shut off the current to the main filament if the pressure goes above a set limit. So, you must depend on alternate leak detection methods, or use the detector-probe technique to discover large leaks. Once large leaks have been discovered and closed, you can concentrate on the smaller leaks that can be found with the tracer-probe technique. 

The source operating pressure is the vacuum necessary to operate the leak detection device. This pressure is not specific, rather it is a pressure range within the leak detector which works. Optimistically, we want the helium leak detector, and the system to which it is connected, to have the greatest possible vacuum. This gives the tracer-probe technique the maximum sensitivity with the quickest response time. As an added benefit, when one is operating at a very high vacuum,... 

---

See also in sourсe #XX -- [ , , ]

---