Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Heat exchanger pressure drop

Heat-exchange pressure drop Optimum pressure drop... [Pg.82]

Air-cooled Heat Exchangers Pressure Drop Air Side... [Pg.43]

Calculate horsepower per fan from the previous section, Air-cooled Heat Exchangers, Pressure Drop, Air Side. [Pg.46]

Water is pumped from an atmospheric tank into a vessel at 50 psig through a heat exchanger. There is a bypass around the heat exchanger. The pump has a flat curve. The heat exchanger pressure drop is 30 psi with 200 gpm of flow through it Size the pump and the two control valves so that ... [Pg.251]

By relating this cost to the design parameters of the heat exchanger (pressure drop and warm-end temperature difference), the parameter values that minimize the total cost are determined. [Pg.195]

Here the + sign denotes vertical upflow (i.e., pressure drop), the sign denotes vertical downflow (i.e., pressure rise or recovery). The first three components of the core pressure drop are now presented for plate-fin, tube-fin, regenerative, and plate heat exchangers. Pressure drop on the shellside of a shell-and-tube heat exchanger is presented in Table 17.31. [Pg.1297]

Plate Heat Exchangers. Pressure drop in a plate heat exchanger consists of three components (1) pressure drop associated with the inlet and outlet manifolds and ports, (2) pressure drop within the core (plate passages), and (3) pressure drop due to the elevation change. The... [Pg.1299]

Heuristic 31 Estimate heat-exchanger pressure drops as follows ... [Pg.185]

Performance when unit is clean (heat exchanged, pressure drop on tube and shell sides)... [Pg.126]

Heat exchanger pressure drop is mainly a function of velocity, that is, tube velocity for tube side pressure drop and bundle velocity for shell side pressure drop. [Pg.94]

A centrifugal fan diverts about 3.5 per cent of the total smoke flow through the Amazone heat exchanger. Pressure drop across the exchanger is between 5 and 10 mm water gauge. [Pg.70]

A pump furnishes a constant head of 40 psi over the entire flow rate range of interest. The heat exchanger pressure drop is 30 psig at 200 gai/min q and can be assumed to be proportional to q. Select the rated Cy of the valve and plot the installed characteristic for the following cases ... [Pg.160]

See other pages where Heat exchanger pressure drop is mentioned: [Pg.886]    [Pg.517]    [Pg.392]    [Pg.463]    [Pg.1371]    [Pg.672]    [Pg.94]    [Pg.110]    [Pg.159]    [Pg.667]    [Pg.397]   
See also in sourсe #XX -- [ Pg.661 ]

See also in sourсe #XX -- [ Pg.822 ]

See also in sourсe #XX -- [ Pg.150 ]

See also in sourсe #XX -- [ Pg.413 , Pg.430 , Pg.435 ]

See also in sourсe #XX -- [ Pg.194 , Pg.198 , Pg.208 , Pg.225 ]



SEARCH



Air-cooled heat exchanger pressure drop

Heat exchanger shell-side pressure drop

Heat exchangers pressure drop air side

Heat exchangers pressure drop analysis

Heat exchangers pressure drop limitations

Heat exchangers, baffles pressure drop

Nozzles pressure drop, heat exchanger

Pressure drop considerations, heat exchangers

Pressure drop correlations, heat exchangers

Pressure drop exchangers

Pressure drop heat exchanger example

Pressure drop heat exchanger shells

Pressure drop heat exchanger tubes

Pressure drop in heat exchangers

Pressure drop plate heat exchangers

Pressure exchangers

Tube-side pressure drop, heat exchangers

© 2024 chempedia.info