Growth rate, specific maximum

Kolmogorov eddy length (microscale of turbulence) (L) specific growth rate (T1) maximum specific growth rate (T1) kinematic viscosity (L2 T"1)... 

Fig. 2. Influences of shear on specific growth rate and maximum cell concentration oiPerilla frutescens cells in a plant cell reactor with a marine impeller. Circles larger impeller (85 mm diam.) triangles smaller impeller (65 mm diam.)...

Table 3.1 shows the kinetic parameters for cell growth, rate models with or without inhibition and mass transfer coefficient calculation at various acetate concentrations in the culture media. The Monod constant value, KM, in the liquid phase depends on some parameters such as temperature, initial concentration of the carbon source, presence of trace metals, vitamin B solution, light intensity and agitation speeds. The initial acetate concentrations in the liquid phase reflected the value of the Monod constants, Kp and Kp. The average value for maximum specific growth rate (/xm) was 0.01 h. The value... 

The maximum specific growth rate is retarded with non-competitive inhibitor. The apparent specific growth rate, vgr > is smaller than the ordinary specific growth rate, umax. 

Kfvv Appai-ent Michaelis constant, g-l1 umS Apparent maximum specific growth rate constant, li 1... 

The Monod rate model is valid for a CSTR bioreactor with maximum specific growth rate of 0.5 li 1 and K, 2 g-1. What would be a suitable dilution rate at steady-state condition, where there is no cell death if initial substrate concentration is 50g-l-1 and yield of biomass on substrate is 100%. 

The parameters of the Monod cell growth model are needed i.e. the maximum specific growth rate and the Michaelis-Menten constant are required for a suitable rate equation. Based on the data presented in Tables 10.1 and 10.2, obtain kinetic parameters for... 

Figure 1 shows that high superficial gas velocity in the airlift bioreactor obviously inhibited growth of H. pluvialis. In this study, the best superficial gas velocity for growth of H. pluvialis was found at the lower limit of the experiment (0.4 cm s ), which providing the maximum cell density and maximum specific growth rate of 77x10 cells mL (2.79 g L of... 

The limiting substrate (glucose) concentration is denoted by S. There are four parameters pmax is the maximum specific growth rate, Ks is the saturation constant for S, kd is the specific death rate and Y is the average yield coefficient (assumed constant). 

The maximum specific growth rate pm, Monod constant Km, and cell yield coefficient Y are constants. In (E4-33), C2o is the inlet glucose concentration. 

---