Group maximum

After single and repeated doses of XYZ123 mean Cmax and AUC were similar in both groups. Maximum values observed in patients were similar or smaller than those observed in healthy subjects. Between subject variability (CV) was around 30% for both groups except for patients on day 7 where it was lower with 20 %. 

Ignition temperature Tj in °C Ignition group Maximum surface temperature1,2 °C... 

In 12 healthy volunteers given oral pimozide 6 mg after 5 days of treatment with clarithromycin (500 mg bd) or placebo, pimozide significantly prolonged the QTC interval in the first 20 hours in both groups (maximum changes in QTC 16 and 13 ms respectively) (3). 

FAO/WHO 2002. Submission and evaluation of pesticide residue data for the estimation of maximum residue levels in food and feed and on the estimation of group maximum residue levels. 

If the bridge contains one carbonyl group, maximum activity is found in derivatives in which the carbonyl group is adjacent to the NH-group as evidenced by the high activity of N-(benzylidene-amino) derivatives prepared from 1-aminohydantoin vs. those prepared from 3-aminohydantoin which are inactive. 

The terms of this model can be divided into three groups maximum surface densities, binding constants, and capacitance terms. For each ion considered there will be a permitted maximum surface density. The values might be identical as for H and OH, or they might be different as for F and HPO . For each ion, there will also be a specific value for the binding constant Kj. And finally there will be a series of capacitance terms which, in effect, specify the distance between the planes of adsorption (provided the electrical permittivity is constant the capacitance is inversely related to distance). 

Prostate Cancer TriaUst s Collaborative Group. Maximum androgen blockade in advanced prostate cancer An overview of the randomised trials. Lancet 2000 355 1491-1498. 

Table 1 shows the main binary oxides and halides formed by transition elements of the 4d and 5d series. Comparison with the corresponding information for the 3d series (Topic H4. Table 1) shows a similar pattern, with early elements in the series forming states up to the group maximum (ZrIV,... 

Anionic thesis of macromonomer of 1,1-diphenylethylene-type unit canying amino group has been performed in a variety of solvents. The product was characterized a combination of H NMR spectroscopic and size exclusion chromatographic analysis. Based on the UV/Visible spectroscopic analysis, the crossover reaction of /i-butyllithium (n-BuLi) with l-[4-bis(trimethylsilyl>amino]phenyl]-l-phenylethylene was found to be so slow in benzene, but it was completed in the benzene/THF mixture within 2 h. The i thesis of macromonomer of thel,l-diphenylethylene-type unit (over 95 %) canying amine-functional group (maximum 94 %) was successful on the basis of H NMR spectroscopic analysis. 

Explosion group Maximum experimental safe gap in mm Test gas... 

At around 2 ppm in the spectrum of the freshly prepared catalyst, three peaks of approximately equal intensity appeared (at 2.1, 1.97 and 1.83 ppm), which merged into one peak (at 1.96 ppm) upon annealing (Sample-101-2). At the same time, the Me-0-CH2-group maximum shifted downfield. the same effect was found with unannealed Sample-101-1 after about one week of storage at room temperature. 

Packing group Maximum packing fraction Coordinate number (points of contact per sphere)... 

Demand for service j in county 2 of insurance and access group Maximum demand of county 2 can be served CHC located county i =Pi n jg g, if the distance between i and z corresponds to level I, 0 otherwise)... 

---