Glass transition temperature, drying

Improved Hot—Wet Properties. Acryhc fibers tend to lose modulus under hot—wet conditions. Knits and woven fabrics tend to lose their bulk and shape in dyeing and, to a more limited extent, in washing and drying cycles as well as in high humidity weather. Moisture lowers the glass-transition temperature T of acrylonitrile copolymers and, therefore, crimp is lost when the yam is exposed to conditions requited for dyeing and laundering. 

The glass-transition temperature, T, of dry polyester is approximately 70°C and is slightly reduced ia water. The glass-transitioa temperatures of copolyesters are affected by both the amouat and chemical nature of the comonomer (32,47). Other thermal properties, including heat capacity and thermal conductivity, depend on the state of the polymer and are summarized ia Table 2. 

As is commonly the case with crystalline polymers the glass transition temperature is of only secondary significance with the aliphatic polyamide homopolymers. There is even considerable uncertainty as to the numerical values. Rigorously dried polymers appear to have TgS of about 50°C, these figures dropping towards 0°C as water is absorbed. At room temperature nylon 66 containing the usual amounts of absorbed water appears to be slightly above the T ... 

Polymeric binder can be added to the network either as an aqueous latex dispersion or as a solution that should be dried prior to lamination in this process. In either case, the polymer should form a film and join adjacent fibers together and thus improve the stress transfer characteristics of the fibrous network. Provided that the proper film forming conditions are available, the property profile of the bonded network is determined to a significant degree by the properties of the polymeric binder at the temperature of use [20,22]. For example, if a softer type of product is desired, a binder with a relatively low glass transition temperature Tg) is often chosen. 

Table 1. Comparison between water uptakes, dry, wet and theoretical glass transition temperatures of TGDDM-DDS samples...

Polymer Processing. Polymer films were cast in trimethylsilyl coated glass molds from membrane filtered 15% (w/v) methylene chloride or chloroform solutions. Transparent films were obtained which were dried to constant weight in high vacuum. Rectangular strips or round disks were cut from the films. For compression molding a Carver laboratory press equipped with thermostated, heated platens was used. Polymers were placed in a stainless steel mold and heated to 40 °C above their glass transition temperature. Then a load of 1-2 tons was applied for 5 min. 

As the temperature is lowered further, the viscosity of the unfrozen solution increases dramatically until molecular mobility effectively ceases. This unfrozen solution will contain the protein, as well as some excipients, and (at most) 50 per cent water. As molecular mobility has effectively stopped, chemical reactivity also all but ceases. The consistency of this solution is that of glass, and the temperature at which this is attained is called the glass transition temperature Tg-. For most protein solutions, Tg- values reside between -40 °C and -60 °C. The primary aim of the initial stages of the freeze-drying process is to decrease the product temperature below that of its Tg- value and as quickly as possible in order to minimize the potential negative effects described above. 

---