General Arrangement

Figure 4 shows the general arrangement and nomenclature for a humidification or dehumidification process, where the subscript 1 refers to the bottom of the column, and subscript 2 to the top. Steady state is assumed. Flow rates and compositions are given in molar terms because this simplifies the results. 

General arrangement (b1) Low start but high running torques... 

Figure 1.26(a) General arrangement of a shaded pole motor... 

Figure 8.6 General arrangement of a constant filled coupling...

Figure 13.8 A typical general arrangement of a double front panel with a walkway gallery (Courtesy ECS)...

Figure 14.3 General arrangement of a power circuit to conduct a short-circuit test...

Figure 16.11 illustrates a general arrangement of such an AMF panel and the above alarm and annunciation provision.s. 

Refer to the general arrangement of this breaker in Figure 19.4. In this device the moving contacts make and break in an oil bath. When the arc is formed during an interruption, the oil becomes decomposed due to excessive heat, and produces a few gases and vapours such as H2... 

Refer to the general arrangement of this breaker in Figure 19.9(a), and (b). 

Refer to general arrangements of sueh breakers in different ratings as shown in Figures 19.14-19.16. 

Figure 19.15 General arrangement of a 3-12 kV, SFe circuit breaker in a bousing (Courtesy Voltas)...

Refer to the general arrangement of a loose breaker show n in Figure 19.22 and its housing (Figure 19.2.1). 

Figure 19.23 General arrangement of a 7.2-36 kV vacuum circuit breaker in a housing (Courtesy Siemens)...

Figure 28.33(b) General arrangement of a typical running section of the busduct of Figure 28.33(a)... 

There are many modifications of the horizontal-tube evaporator, but these consist largely of changes in the shape of the body castings and not at all in the general arrangement or interrelationship of the parts. The horizontal-tube evaporator is best suited for non-viscous solutions that do not deposit scale or crystals on evaporation. Its first cost per square foot of heating surface is usually less than that of the other types of evaporators. 

The Vendor shall provide general arrangement, detail and other drawings as listed in the material requisition. 

General arrangement drawings with location and characteristics of terminal points,... 

---