Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Fragmentor voltage

Fragmentor voltage Over 220 V Under 90 V 110-150V Collision-induced dissociation effect Poor ionization efficiency Good ionization efficiency... [Pg.205]

Fragmentor voltage Another term for cone-voltage fragmentation. [Pg.306]

A sensitive and rapid chromatographic procedure using a selective analytical detection method (electrospray ionization-mass spectrometry in SIM mode) in combination with a simple and efficient sample preparation step was presented for the determination of zaleplon in human plasma. The separation of the analyte, IS, and possible endogenous compounds are accomplished on a Phenomenex Lima 5-/rm C8(2) column (250 mm x 4.6 mm i.d.) with methanol-water (75 25, v/v) as the mobile phase. To optimize the mass detection of zaleplon, several parameters such as ionization mode, fragmentor voltage, m/z ratios of ions monitored, type of organic modifier, and eluent additive in the mobile phase are discussed. Each analysis takes less than 6 min. The calibration curve of zaleplon in the range of 0.1-60.0 ng/ml in plasma is linear with a correlation coefficient of >0.9992, and the detection limit (S/N = 3) is 0.1 ng/ml. The within- and between-day variations (RSD) in the zaleplon plasma analysis are less than 2.4% (n = 15) and 4.7% (n = 15), respectively. The application of this method is demonstrated for the analysis of zeleplon plasma samples [14]. [Pg.363]

S. N. Pedersen, K. A. Francesconi, Liquid chromatography electrospray mass spectrometry with variable fragmentor voltages gives simultaneous elemental and molecular detection of arsenic compounds, Rapid Common. Mass Spectrom., 14 (2000), 641-645. [Pg.594]

Fragmentor voltage 80 V Gas temperature 350 °C Drying gas 10 1/min Nebuliser pressure 40 psig Capillary voltage 4000 V... [Pg.364]

Using a high fragmentor voltage of 290 V, BADGE and its derivatives were detected using specific ion monitoring at m/z 211 (Eig. 16.2). Some differences in sensitivity were observed as shown in Eig. 16.3. [Pg.366]

Thiabendazole showed a protonated molecule at m/z 202 in positive-ion APCI and ESI [19, 23], At higher fragmentor voltages, a fragment due to the loss of HCN was observed [19]. [Pg.191]

Vinclozolin, procymidone, iprodione, and 3,5-dichlorophenyl hydan-toin (the iprodione degradation product) in wine were determined by SBSE and negative-ion liquid desorption-APCI (fragmentor voltage 70V, capillary voltage 4000V, mass range m/z 200-350) (Sandra et al.,... [Pg.312]

Fragmentor voltages 20V positive mode, -40V negative mode (Fernandez et al., 2000). [Pg.314]


See other pages where Fragmentor voltage is mentioned: [Pg.205]    [Pg.39]    [Pg.317]    [Pg.388]    [Pg.148]    [Pg.220]    [Pg.221]    [Pg.261]    [Pg.286]    [Pg.468]    [Pg.287]    [Pg.580]    [Pg.253]    [Pg.324]    [Pg.366]    [Pg.187]    [Pg.191]    [Pg.191]    [Pg.191]    [Pg.350]    [Pg.178]    [Pg.317]    [Pg.396]    [Pg.784]    [Pg.147]    [Pg.149]    [Pg.381]    [Pg.755]    [Pg.1185]    [Pg.225]    [Pg.197]    [Pg.512]   
See also in sourсe #XX -- [ Pg.317 ]




SEARCH



© 2024 chempedia.info