Flip chip on flex

Li, L. Fang, T. Anisotropic conductive adhesive films for flip chip on flex packages. Proceedings of the 4th International Conference on Adhesive Joining and Coating Technology in Electronics Manufacturing, Helsinki, Finland, June 2000 129-135. 

Chip-on-flex is similar to chip-on-board except that the die, chips, or CSPs are wire bonded, flip chip attached, or epoxy connected to a flexible circuit instead of to a rigid interconnect substrate such as a PWB. 

Electrical conductivity in anisotropic adhesives occurs by a mechanism different from that of isotropic adhesives. Although metal fillers are also used, they are used in much lower amounts (0.5-5% by volume) so that the adhesive is essentially an insulator in the x-y directions. On inserting the adhesive between the electrodes (for example, the metal bumps of a flip-chip device with metal pads on a flex circuit) of two parts and applying pressure and heat, the metal particles form a z-direction electrical connection between the electrodes while the surrounding material remains insulating. The... 

Several approaches using electrically conductive adhesives instead of solder have been explored and are proving successful. Anisotropic adhesives (See Chapter 1), for example, have been used to connect flex circuits and cables from the separate driver circuits to the panel, avoiding the use of solder connections. More importantly, integrated-circuit chips can be bonded directly to the ITO conductor traces on the panel, a technology called chip-on-glass (COG). IC chips can be flip-chip bonded, then underfilled with a stress-free underfill adhesive if necessary. For protection, the chips may then be encapsulated with epoxy (glob-topped). 

ACA flip chip bonding exhibits better reliability on flexible chip carriers because the ability of flex provides compliance to relieve stresses. For example, the internal stress generated during resin curing can be absorbed by the deformation of the chip carrier. ACA joint stress analysis conducted by Wu and co-workers indicated that the residual stress is larger on rigid substrates than on flexible substrates after bonding (14). 

---