Fixed dispersion processes

The energy balance for a general fixed-bed process, ignoring dispersion, is... 

ChemaL [Chemax] Ethoxylated ethers, esters, sulfosuccinates wetting agent, penetrant, emulsifier, lubricant, detergent, dispersant, solubilizer fix textile processing, cosmetics, polishes,... 

Most methods of separating molecules in solution use direct contact of immiscible fluids or a sohd and a fluid. These methods are helped by dispersion of one phase in the other, fluid phase, but they are hindered by the necessity for separating the dispersed phase. Fixed-bed adsorption processes overcome the hindrance by immobilizing the solid adsorbent, but at the cost of cyclic batch operation. Membrane processes trade direct contact for permanent separation of the two phases and offer possibilities for high selectivity. 

When a number of competing reactions are involved in a process, and/or when the desired product is obtained at an intermediate stage of a reaction, it is important to keep the residence-time distribution in a reactor as narrow as possible. Usually, a broadening of the residence-time distribution results in a decrease in selectivity for the desired product. Hence, in addition to the pressure drop, the width of the residence-time distribution is an important figure characterizing the performance of a reactor. In order to estimate the axial dispersion in the fixed-bed reactor, the model of Doraiswamy and Sharma was used [117]. This model proposes a relationship between the dispersive Peclet number ... 

Crystallization involves formation of a solid product from a homogeneous liquid mixture. Often, crystallization is required as the product is in solid form. The reverse process of crystallization is dispersion of a solid in a solvent, termed dissolution. The dispersed solid that goes into solution is the solute. As dissolution proceeds, the concentration of the solute increases. Given enough time at fixed conditions, the solute will eventually dissolve up to a maximum solubility where the rate of dissolution equals the rate of crystallization. Under these conditions, the solution is saturated with solute and is incapable of dissolving further solute under equilibrium conditions. In fact, the distinction between the solute and solvent is arbitrary as either component can be considered to be the solute or... 

---