Extrusion, manufacturing process

In the two typical shaft seal manufacturing processes shown in Fig. 2, the extrusion process is only required if the compression molding process is being used. There are basically two types of extruders in general use, the cold feed and the hot feed. In both cases their role is to produce the preforms for use with compression molding. The critical issues with the preform are the shape, the dimensions, and the weight. 

Designers and processors to produce products at the lowest cost have unconsciously used the basic concept of the FALLO approach. This approach makes one aware that many steps are involved to be successful, all of which must be coordinated and interrelated. It starts with the design that involves specifying the plastic, and specifying the manufacturing process. The specific process (injection, extrusion, blow molding, thermoforming, and so forth) is an important part of the overall scheme and should not be problematic. 

Plastic products are made by a variety of basic manufacturing processes. As an example a major method such as extrusion has subdivisions that include profile, pipe, tube, film, sheet, coating, post forming, etc. equipment In injection molding there are subdivisions such as coinjection, gas assist, foam, inmold decorating, etc. equipment. There are literally hundreds of processes used with only about the dozen, as reviewed in this chapter, that are principally used (2). 

The manufacturing process is sometimes discussed in terms of the characteristics of the active ingredient, e.g., the need for nonaqueous granulation processes, the need for controlled humidity in the manufacturing environment. The number of different manufacturing sites requested is mentioned in the assessment reports. Special manufacturing processes such as extrusion/ spheronization are mentioned in the EPARs. 

In addition to the conventional dyeing of acrylic fibres, there is considerable interest in so-called gel dyeing of acrylic filaments during the manufacturing process after extrusion. From the viewpoint of auxiliary usage this is outside the scope of the present work, but a useful account of the factors involved is available [61]. 

Catalyst manufacturing processes usually make particles in a distribution of sizes, although special shapes such as Raschig rings or cylinders made by extrusion and other shapes made by stamping may be quite uniform. Size distribution is measured by sieving or elutriation. A mean diameter is a convenient quantity. The kind of mean value that is applicable when surface is the main property of interest is the volume-surface mean that is applied in P7.01.09. 

---