Excited the directly

Because of the nature of longitudinal excitation, the direction of the E field is determined by the direction of the momentum transfer. 

Therefore, we may say that head wave is the excited shear wave when longitudinal wave is spreading along boundaries. This is the head wave which we often call. In Fig.3 the wavefront of head wave is indicated by AB. The biggest circular arc AC in Fig.3 is the wavefront of longitudinal wave. The small arrow beside the circular line indicates the direction of displacement after the wavefront arrives and the written character 8 nearby indicates its... 

Surface photochemistry can drive a surface chemical reaction in the presence of laser irradiation that would not otherwise occur. The types of excitations that initiate surface photochemistry can be roughly divided into those that occur due to direct excitations of the adsorbates and those that are mediated by the substrate. In a direct excitation, the adsorbed molecules are excited by the laser light, and will directly convert into products, much as they would in the gas phase. In substrate-mediated processes, however, the laser light acts to excite electrons from the substrate, which are often referred to as hot electrons . These hot electrons then interact with the adsorbates to initiate a chemical reaction. 

Some recent advances in stimulated desorption were made with the use of femtosecond lasers. For example, it was shown by using a femtosecond laser to initiate the desorption of CO from Cu while probing the surface with SHG, that the entire process is completed in less than 325 fs [90]. The mechanism for this kind of laser-induced desorption has been temied desorption induced by multiple electronic transitions (DIMET) [91]. Note that the mechanism must involve a multiphoton process, as a single photon at the laser frequency has insufScient energy to directly induce desorption. DIMET is a modification of the MGR mechanism in which each photon excites the adsorbate to a higher vibrational level, until a suflBcient amount of vibrational energy has been amassed so that the particle can escape the surface. 

The conmron flash-lamp photolysis and often also laser-flash photolysis are based on photochemical processes that are initiated by the absorption of a photon, hv. The intensity of laser pulses can reach GW cm or even TW cm, where multiphoton processes become important. Figure B2.5.13 simnnarizes the different mechanisms of multiphoton excitation [75, 76, 112], The direct multiphoton absorption of mechanism (i) requires an odd number of photons to reach an excited atomic or molecular level in the case of strict electric dipole and parity selection rules [117],... 

Figure B2.5.13. Schematic representation of the four different mechanisms of multiphoton excitation (i) direct, (ii) Goeppert-Mayer (iii) quasi-resonant stepwise and (iv) incoherent stepwise. Full lines (right) represent the coupling path between the energy levels and broken arrows the photon energies with angular frequency to (Aco is the frequency width of the excitation light in the case of incoherent excitation), see also [111].

We shall consider just two examples of the use of femtosecond lasers in spectroscopy. One is an investigation of the transition state in the dissociation of Nal and the other concerns the direct, time-based observation of vibrational energy levels in an excited electronic state of I2. 

In a skimmed supersonic jet, the parallel nature of the resulting beam opens up the possibility of observing spectra with sub-Doppler resolution in which the line width due to Doppler broadening (see Section 2.3.4) is reduced. This is achieved by observing the specttum in a direction perpendicular to that of the beam. The molecules in the beam have zero velocity in the direction of observation and the Doppler broadening is reduced substantially. Fluorescence excitation spectra can be obtained with sub-Doppler rotational line widths by directing the laser perpendicular to the beam. The Doppler broadening is not removed completely because both the laser beam and the supersonic beam are not quite parallel. 

Resonance Raman Spectroscopy. If the excitation wavelength is chosen to correspond to an absorption maximum of the species being studied, a 10 —10 enhancement of the Raman scatter of the chromophore is observed. This effect is called resonance enhancement or resonance Raman (RR) spectroscopy. There are several mechanisms to explain this phenomenon, the most common of which is Franck-Condon enhancement. In this case, a band intensity is enhanced if some component of the vibrational motion is along one of the directions in which the molecule expands in the electronic excited state. The intensity is roughly proportional to the distortion of the molecule along this axis. RR spectroscopy has been an important biochemical tool, and it may have industrial uses in some areas of pigment chemistry. Two biological appHcations include the deterrnination of helix transitions of deoxyribonucleic acid (DNA) (18), and the elucidation of several peptide stmctures (19). A review of topics in this area has been pubHshed (20). 

---